Wipers for Nissan Qashqai J10: sizes, part numbers and selection nuances

Replacing wipers with Nissan Qashqai J10 (first generation, 2007–2013) - a seemingly simple procedure, but even here there are pitfalls. Incorrectly selected brushes not only clean the glass worse, but can also damage the windshield wiper mechanism or leave scratches on the windshield. In this article we will analyze exact dimensions of wipers for all modifications of the J10, including heated options, and we will also tell you how to avoid common mistakes when purchasing and installing.

Feature Qashqai J10 — non-standard length of brushes for some configurations. For example, wipers for version with panoramic roof may differ from the base model. In addition, there are counterfeits of original articles on the market. Nissan, which are visually indistinguishable, but serve 2–3 times less. We have collected verified data on sizes, items and brands that are guaranteed to fit.

Official wiper sizes for Nissan Qashqai J10

Standard wiper blade sizes for Nissan Qashqai J10 (2007–2013) depend on the year of manufacture and configuration. Here are the basic parameters:

• 🚗 Driver's side (left wiper): 600 mm (24 in) - this is the most common size for all modifications of the J10.
• 🚗 Passenger side (right wiper): 400 mm (16 inches) - for most versions, but there are exceptions (see table below).
• 🔥 Rear wiper (if installed): 300–350 mm - depends on the body type (with or without a panoramic roof).

Important: on some restyled models Qashqai J10 (after 2010) brushes were installed with asymmetrical fastening, which can complicate the selection of analogues. If your car is equipped with a system Rain-Sensing Wipers (rain sensor), special frameless wipers with a uniform fit are required.

Modification of Qashqai J10	Left wiper (driver)	Right wiper (passenger)	Rear wiper	Notes
Basic (2007–2010)	600 mm	400 mm	300 mm	Fastening U-hook (9x3 mm)
Restyling (2010–2013)	600 mm	450 mm	350 mm	Mounting possible Pinch Tab
With panoramic roof	600 mm	400 mm	—	The rear wiper is not installed
Heated	600 mm	400/450 mm	300 mm	Requires brushes with metal contacts

⚠️ Attention: If on your Qashqai J10 Wipers of non-standard length are installed (for example, 550 mm instead of 600 mm), probably the previous owner replaced them with non-original ones. In this case, check article number on the back of the brush or check the vehicle's VIN.

Original articles and analogues: what to choose?

Original wipers Nissan for Qashqai J10 have the following articles:

• 📌 Left wiper: 28511-JM00A (600 mm) or 28511-4M00A (for restyling).
• 📌 Right wiper: 28512-JM00A (400 mm) or 28512-4M00A (450 mm).
• 📌 Rear wiper: 28530-JM00A (300 mm).

The cost of original brushes is from 1,500 to 3,000 rubles per set. However, many owners choose analogues from trusted brands, which are not inferior in quality, but are 2-3 times cheaper. Best Alternatives:

Brand	Article (left/right)	Mounting type	Average price, ₽
Bosch	A330H / A194S	Universal	1 200–1 500
Denso	WU-24 / WU-16	U-hook	900–1 100
Valeo	600140 / 600062	Pinch Tab	800–1 000
HELLA	HW600 / HW400	Adapter included	700–900

💡 Advice: When purchasing analogues, pay attention to fastening type. On Qashqai J10 most often used U-hook (9x3 mm), but on restyled models it may be Pinch Tab or Side Pin. If you're not sure, take your old brush with you to the store for comparison.

How to determine the type of windshield wiper mounting on a Qashqai J10?

An error in the choice of mounting is the most common reason why new wipers do not fit. On Nissan Qashqai J10 meet 4 types of fastenings:

1. U-hook (9x3 mm) - the most common option. Looks like a hook with a gap of 9mm and a thickness of 3mm.
2. Pinch Tab - fastening with side latches. Often used on restyled models after 2010.
3. Side Pin - mount with side pin. Available on heated versions.
4. Bayonet - a rare type, similar to a bayonet joint. Used on some European trim levels.

🔍 How to check? Remove the old wiper and look at where it attaches to the arm. If you see:

• 🔹 The hook is U-hook.
• 🔹 Plastic latches on the sides - Pinch Tab.
• 🔹 Metal pin on the side - Side Pin.

⚠️ Attention: If you bought wipers with incompatible mountings, do not try to “fit” them - this may lead to broken windshield wiper arm. It is better to return the product to the store or buy an additional adapter (costs 100–200 rubles).

Remove the old brush and determine the type of fastening|

Measure the length of the wiper with a tape measure (from edge to edge)|

View the article number on the back of the old brush|

Find out if there is heating (if so, look for brushes with metal contacts) |

Check compatibility with rain sensor (if installed)

-->

Step-by-step instructions for replacing wipers

Replacing brushes with Nissan Qashqai J10 It takes no more than 10 minutes, but there are nuances that will help you avoid mistakes:

1. Preparation: Park the vehicle on a level surface and turn off the ignition. Raise the wiper arm perpendicular to the windshield (service position).
2. Removing the old brush:
   • Press down on the latch (usually located on the side or bottom).
   • Pull the brush down, sliding it along the lever.
   • If the mount U-hook, simply slide the brush off the hook.
3. Installing a new brush:
   • Align the new brush mount with the lever.
   • Snap the latch (a characteristic click should be heard).
   • Make sure that the brush fits snugly along its entire length.

Check: Turn on the wipers in washer mode and check whether skips or squeaks.

⚠️ Attention: Do not use force when removing the brush - if it does not give in, it means you did not press the latch. On Qashqai J10 with the system Rain-Sensing Wipers may be required after replacement error reset through the on-board computer (if the wipers operate jerkily).

What to do if the wipers do not work evenly after replacement?

If new brushes “bounce” or leave streaks, the reasons may be the following:

1. **Wrong length** - even a difference of 20-30 mm leads to imbalance.

2. **Contamination of the lever** - clean the mounting axle from rust or old grease.

3. **Trapezium wear** - if the problem persists, check the windshield wiper mechanism (may require repair).

4. **Poor quality brushes** - cheap analogues often have uneven pressure along the length.

Common mistakes when choosing and installing wipers

Even experienced car owners sometimes make mistakes that lead to premature wear of the brushes or breakdown of the mechanism. Here are the most common:

• ❌ Buying wipers by eye — the sizes 580 mm and 600 mm are visually almost the same, but a 20 mm difference is enough for the brush not to reach the edge of the glass.
• ❌ Ignoring Mount Type - for example, trying to install a brush with Side Pin on the lever under U-hook.
• ❌ Saving on quality - wipers costing 200–300 rubles last 1–2 months and often scratch the glass.
• ❌ Late replacement - worn blades increase the load on the windshield wiper motor, which can lead to its failure.
• ❌ Installation without verification — if you don’t test your wipers right away, you may miss the moment when they start to “hit” the glass.

💡 Helpful tip: If on your Qashqai J10 Heated wipers are installed, never buy regular wipers! They are missing metal contacts, and the heating system will not work. Original article numbers for heated versions: 28511-4M01A (left) and 28512-4M01A (right).

When is it time to change wipers? 5 signs of wear

Manufacturers recommend replacing windshield wiper blades every 6–12 months, but in practice the period depends on the intensity of use and climatic conditions. Here are clear signs that it's time to replace your wipers:

• 🌧️ Stripes on glass — the brush does not fit tightly and leaves uncleaned areas.
• 🔊 Creaking or knocking - indicates wear of the rubber or deformation of the frame.
• 🧊 Ice or snow does not move - even with the heating on.
• 🔍 Visible cracks in rubber - especially around the edges.
• 🚿 Stains after washer — the liquid is not distributed evenly.

⚠️ Attention: If there are microcracks in areas where wipers operate, this may be a consequence of the use of worn brushes with metal elements (for example, after winter). In this case, polishing or replacing the glass will be required.

🔧 Care tip: To extend the life of your wipers, regularly clean them of dirt and snow, and also use special washer fluid (not water!). In winter, before parking, raise the blades to prevent them from freezing to the glass.

FAQ: Answers to frequently asked questions about Qashqai J10 wipers

Is it possible to install wipers longer than the original?

No, this will lead to:

• 🔹 Increased load on the wiper motor.
• 🔹 Possible brushes getting caught on the racks or hood.
• 🔹 Uneven fit and divorces.

Maximum permissible deviation - ±10 mm from the original size.

Which brand of wipers lasts the longest?

According to owner reviews Qashqai J10, the best options:

1. Bosch Aerotwin — frameless, last up to 1.5 years.
2. Denso Hybrid - optimal for winter.
3. Valeo Silencio - quiet and wear-resistant.

Budget analogues (HELLA, SWF) lasts for 6–8 months.

What to do if the wipers are frozen to the glass?

Do not try to turn them on by force! This may burn out the motor. Proceed like this:

1. Start the engine and turn on glass heating.
2. Pour warm (not hot!) water over the ice layer.
3. Gently pry the brush out with a plastic spatula.
4. After thawing, treat the rubber silicone grease.

Will wipers from Nissan Qashqai J11 fit J10?

No, y Qashqai J11 (second generation) other sizes:

• 🔹 Left: 650 mm (versus 600 mm for J10).
• 🔹 Right: 400 mm (same, but mounting may vary).

Installing wipers from J11 to J10 will lead to incomplete cleaning of glass and possible damage to the mechanism.

Do the wiper shafts need to be lubricated?

Yes, but only special lubricant (For example, LIQUI MOLY Silicone-Fett). Do this once a year:

1. Remove the brush from the lever.
2. Clean the axle of old grease and dirt.
3. Apply a thin layer of new grease.

This will prevent squeaking and corrosion.