Rear wiper on Nissan Note E11 (2006–2013) - a seemingly simple mechanism, but its failure can seriously impair visibility in rain or snow. Owners often experience that the wiper suddenly stops moving, operates jerkily, or does not respond to the switch at all. In 80% of cases, the problem is solved without visiting a service center - it’s enough to know where to look for the problem and how to fix it.

In this article we will analyze all possible reasonswhy the rear wiper doesn't work Note E11 - from a banal blown fuse to wear of gear motor gears. You'll learn how to test an electrical circuit with a multimeter, where the wiper relay is located, and when it's time to replace the entire mechanism. And for those who prefer visual instructions, we have prepared step by step photos key stages of repair.

Let us warn you right away: if the wiper is stuck in the upper position and you can hear the hum of the motor, do not try to force the lever to move - this will lead to cable breakage or gearbox failure. In such cases, careful disassembly and diagnostics are required. Let's start with the simplest thing - checking the fuse.

1. Rear wiper fuse: where is it located and how to check

The first thing to do if the rear wiper fails is to check the fuse. B Nissan Note E11 it is located in mounting block under the steering wheel (driver's side). This is a fuse F30 face value 10A, which is also responsible for heating the rear window.

To get to it:

  • 🔧 Open the fuse box cover (press the latch at the bottom of the panel).
  • 🔍 Find the fuse F30 (its position is indicated on the back of the cover).
  • 📍 Remove the fuse with pliers or tweezers and inspect the filament.

If the fuse is blown, replace it with a new one same denomination. Using a high ampere fuse may result in a wiring fire! If the new fuse immediately blows when the wiper is turned on, there is short circuit, and wiring diagnostics are required.

⚠️ Attention: Never replace the rear wiper fuse with a bug (jumper wire). This may damage the body electronics control unit (BCM), the repair of which will cost 15–20 thousand rubles.
📊 How often do you check the fuses in your car?
  • Only when something breaks
  • Once every six months
  • Once a year
  • Never

2. Rear wiper relay: location and diagnostics

If the fuse is good, but the wiper does not work, the next step is to check the relay. B Nissan Note E11 rear wiper relay (K30) is located there, in the mounting block under the steering wheel. It is responsible for supplying power to the motor and protects the circuit from overloads.

How to check the relay:

  1. Remove the relay K30 (its location is indicated in the diagram under the block cover).
  2. Take a working relay with the same number (for example, from turn signals or a horn) and install it instead K30.
  3. Turn on the rear wiper - if it works, it means the old relay is faulty.

If you don’t have a known working relay at hand, you can check it with a multimeter:

  • 📊 Switch the tester to resistance test mode (200 Ohm).
  • 🔌 Connect the probes to the contacts 85 And 86 (coil winding). There must be resistance 50–120 Ohm.
  • 🔋 Serve 12V to contacts 85 And 86 - a click should be heard (contacts closing 30 And 87).
Symptom Probable Cause Remedy
The wiper does not work, the fuse is intact Relay faulty K30 Replacing the relay (cost ~300–500 rubles)
The wiper only works in one mode Relay contacts burnt out Cleaning contacts or replacing relays
Clicking noises from under the panel when turned on The relay operates, but there is no contact on the motor Checking the wiring from the relay to the motor
💡

If the relay clicks but the wiper does not move, the problem may be oxidized contacts of the gear motor connector. Try turning the wiper on/off several times - sometimes this helps to “break through” the oxidation.

3. Rear wiper gear motor: diagnostics and replacement

If the fuse and relay are good, but the wiper still does not work, the problem is most likely gear motor. This is the most vulnerable node of the system, especially on machines older than 10 years. B Nissan Note E11 The motor is located under the plastic trim in the rear door (driver's side).

Signs of a gear motor malfunction:

  • 🔊 The wiper does not move, but the hum of the motor is heard - the gears of the gearbox are worn out.
  • ⚡ The wiper works jerkily or stops in an arbitrary position - problems with the brushes or collector.
  • 🚫 Complete lack of response to switching on - winding breakage or lack of power.

For diagnostics:

  1. Remove the plastic trim of the rear door (unscrew the 2 screws under the plugs and carefully pry up the clips).
  2. Disconnect the power connector from the motor and check for 12V on the contacts when the wiper is on (contact + - red wire, – - black).
  3. If there is power, but the motor does not rotate, replacement is required.

Replacing the gear motor with Note E11 takes ~1 hour. The average cost of a new motor is 2,500–4,000 rub., used - 1,000–1,800 rub.. When purchasing, pay attention to the article number: original number - 28550-4M000 (or 28550-4M00A for restyled models).

No mechanical obstacles (ice, dirt)

Integrity of wiring from relay to motor

Availability of power at the motor connector

Condition of the gears (if you are disassembling the old motor)

-->

4. Wiper cable and lever: mechanical failure

If the motor is working properly, but the wiper does not move, the problem may lie in cable or lever. B Nissan Note E11 A cable transmission is used from the gear motor to the wiper arm. Over time, the cable stretches, frays or breaks, and the lever may bend from mechanical stress (for example, if the wiper freezes in winter).

How to diagnose:

  • 🔍 Remove the plastic protection under the rear window (unscrew 4 screws).
  • 🖐️ Check the cable tension - if it is sagging or torn, it will need replacement.
  • 🔧 Inspect the wiper arm for deformation or cracks.

Replacing the cable is a labor-intensive procedure, as it requires disassembling almost the entire rear door. The average cost of a cable is 800–1,500 rub., service work - 2,000–3,500 rub.. If the lever is bent, it can be straightened with pliers, but if it is cracked, it will need to be replaced (part number - 28531-4M000).

⚠️ Attention: When replacing a cable, be sure to lubricate the new cable. silicone grease - this will extend its service life and prevent freezing in winter. Do not use lithol or grease - they collect dirt.
How to temporarily restore wiper operation if the cable is broken

If the cable is torn, but the motor is working properly, you can temporarily connect its ends with thin steel wire (diameter ~1 mm). This will allow the wiper to work until the cable is replaced, but do not forget that such a “repair” is unreliable and can lead to jamming of the mechanism.

5. Wiring and connectors: searching for breaks and oxidation

A common reason for rear wiper failure is wiring problems. B Nissan Note E11 the wires from the motor go through a corrugated sleeve in the rear door, which wears out over time. The contacts in the connectors also oxidize, especially if the machine was operated in high humidity conditions.

How to check wiring:

  1. Disconnect the motor connector and check the integrity of the wires with a multimeter in “continuity” mode.
  2. Inspect the wires in the area from the door to the body - they often rub against metal edges.
  3. Clean the connector contacts with sandpaper (600–800 grit) and process contact lubricant (For example, Liqui Moly Kontakt-Spray).

Typical break locations:

  • 🚪 In the corrugation between the back door and the body.
  • 🔌 In the motor connector (oxidation or poor contact).
  • 🔋 In the area from the installation block to the door (wires can rub against metal).

If a break is found, restore the circuit by soldering or replacing a section of wire. Twisting without soldering is a temporary solution that will last no more than a year.

💡

Before soldering wires, be sure to insulate them heat shrink tube - this will protect the contact from moisture and oxidation. The duct tape falls off quickly in a tailgate situation!

6. Wiper switch: faults and repairs

Less often, but still there are cases when the problem lies in rear wiper switch (steering column lever). B Nissan Note E11 it is combined with the front wiper and washer switch. Over time, the contacts inside the switch oxidize or wear out, resulting in incorrect operation.

How to check the switch:

  • 🔧 Remove the plastic steering column cover (unscrew the 2 screws from the bottom and remove the clips).
  • 🔌 Disconnect the switch connector and check the resistance between the contacts at different positions of the lever.
  • 📊 In the “on” position, there is resistance between the contacts 5 And 6 there must be 0 ohm.

If the switch is faulty, it can be replaced (part number - 25520-4M000, price ~1,500–2,500 rub.) or try to disassemble and clean the contacts. To do this:

  1. Carefully disassemble the switch housing (it is secured with latches).
  2. Clean the contacts with alcohol or a special electronics fluid.
  3. Lubricate the moving parts with silicone grease.

If the problem persists after cleaning, the switch must be replaced. Please note that if you purchase a new lever you may need to programming (on some models with CAN bus).

7. Prevention of rear wiper breakdowns

To keep the rear wiper on Nissan Note E11 lasted longer, follow simple recommendations:

  • 🧊 In winter, before turning on the wiper necessarily Clean the glass from ice and snow. A frozen wiper is the main cause of gearmotor failures.
  • 💧 Regularly (once every 3 months) lubricate the cable and gears of the motor silicone grease.
  • 🔧 Once a year, check the fastening of the wiper arm - loose nuts lead to play and wear of the cable.
  • 🚿 Use high-quality washer fluid - cheap compounds contain aggressive additives that corrode rubber seals.

If the wiper starts to work intermittently (jerks, slowdowns), do not delay diagnostics. In the early stages, the problem is often solved by cleaning the contacts or lubricating them, while advanced cases require expensive repairs.

For owners Note E11 with mileage for 150,000 km We recommend keeping a spare wiper motor in the trunk (part number 28550-4M000). Replacing it takes 20 minutes, and the cost for disassembly starts from 1,000 rub..

📊 Have you already experienced a rear wiper breakdown?
  • Yes, I changed the motor
  • Yes, I fixed the wiring
  • Yes, there was another problem
  • No, as long as everything works

FAQ: Frequently asked questions about the rear wiper Nissan Note E11

🔧 Is it possible to repair the gear motor or just replace it?

In most cases, the gearmotor can be repaired. Most often they fail:

  • 🔄 Reducer gears (can be replaced separately, article number 28555-4M000).
  • 🔥 Brushes or commutator (cleaned or replaced).
  • 🧲 Rotor magnets (if demagnetized, the rotor needs to be replaced).

If the motor housing is cracked or the winding is burned out, it is cheaper to buy a new one.

💡 Why does the rear wiper only work in one mode?

This is a typical sign of a problem relay or switch. Relay K30 is responsible for switching between modes (continuous operation/intermittent mode). Check:

  1. Relay contacts for burning.
  2. Integrity of tracks on the switch board.

The problem may also be in the oxidized contacts of the motor connector - clean them and lubricate them.

❄️ How to defrost a rear wiper in winter?

Never turn on the wiper if it is frozen! This will lead to gearbox failure. To defrost:

  • 🔥 Use lock defroster (apply to the rubber part of the wiper).
  • 🚗 Start the car and turn on the rear window heating for 10-15 minutes.
  • 🧊 Gently scrape the ice with a plastic scraper (not metal!).

After defrosting, lubricate the cable and gears silicone grease.

🔌 Where to find the rear wiper wiring diagram for Note E11?

The diagram can be found:

  • 📖 B repair manual (For example, Nissan Note E11 Service Manual).
  • 🌍 On the forums: Drive2.ru, Nissan-Club.ru (in the electrical sections).
  • 📱 In mobile applications like AutoData or Mitchell1.

Motor power wire color - red (+12V), mass - black.

💰 How much does it cost to repair a rear wiper at a service center?

The cost depends on the cause of the breakdown:

Type of work Cost (RUB)
Replacing the fuse/relay 200–500 (on your own)
Electrical diagnostics 500–1 500
Replacing the gear motor 2,000–4,000 (with spare part)
Replacing the cable 3 000–5 000
Wiring repair 1 000–3 000

Do-it-yourself repairs are 2–3 times cheaper!