Windshield Nissan Murano Z51 (2015-2022) is not just a body part, but a critical safety component. It provides up to 30% body rigidity in case of a frontal impact, protects against UV radiation and is the basis for the operation of systems ADAS (adaptive cruise control, traffic sign recognition). However, even a microcrack can lead to failure of cameras and sensors, and incorrect replacement can lead to problems with interior sealing.

In this article we will look at everything the owner needs to know. Murano Z51: from original glass articles to step-by-step replacement instructions, including hidden nuances, which are not talked about in the services. We will also compare prices for the original and analogues, and tell you how to check the quality of the installation and avoid being scammed when buying a used car with replaced glass.

Original windshields for Nissan Murano Z51: articles and features

For Murano Z51 (restyling 2018 inclusive) original glass is supplied by the company AGC (Asahi Glass Co.). They are marked with a logo Nissan and have unique parameters:

  • 🔹 Original article number: 28510-4M00A (until 2018) and 28510-4M01A (after restyling).
  • 🔹 Thickness: 4.8 mm (laminated, with PVB film for protection against splinters).
  • 🔹 Heating zone: integrated heating threads for quick defrosting (important for the Russian climate).
  • 🔹 Coverage: UV filter (blocks up to 98% of ultraviolet radiation), anti-reflective coating.

The original glasses are different perfect geometry - this is critical for camera operation ProPILOT Assist (if installed). Even minimal distortion can lead to false alarms in the system. When purchasing, check availability:

  • 📌 Holograms AGC in the bottom corner.
  • 📌 Production dates (no older than 2 years - over time, PVB film loses its elasticity).
  • 📌 Markings DOT 43 (compliance with American safety standards).
⚠️ Attention: On the market there are counterfeits of the original with the article number 28510-4M00B - this is a non-existent detail! Such glasses often have lamination defects and do not pass the impact test.
Parameter Original (AGC) High-quality analogue (Pilkington/Sekurit) Budget analogue (XYG/FYG)
Cost, ₽ 45 000–55 000 28 000–35 000 12 000–18 000
Warranty 3 years 2 years 6–12 months
ADAS Compatible 100% 95% (requires calibration) 50% (risk of system errors)
UV protection 98% 95% 80–85%
📊 Which glass would you prefer for the Murano Z51?
  • Original (AGC)
  • Premium analogue (Pilkington)
  • Budget analogue (XYG/FYG)
  • I don't know, I need advice

Analogues of windshields: when you can save money and when you can’t

Analogs are 30–70% cheaper than the original, but not all are suitable for Murano Z51. The main selection criterion is Compatible with driver assistance systems. If your car is equipped ProPILOT Assist, Intelligent Cruise Control or Lane Departure Warning, cheap glass can cause:

  • 🚨 False activations of the brake system.
  • 🚨 Lost connection with the camera (error C1A99 in the on-board computer).
  • 🚨 Image distortion for character recognition.

Among the analogues the following stand out:

  • 🔸 Pilkington (article NWG 100516) - the best price/quality balance. Suitable for ADAS, but requires mandatory calibration after installation.
  • 🔸 Sekurit (article 555 100 516) - European quality, but there are problems with heating in cold weather.
  • 🔸 XYG (article GW01-100516-N) is a budget option, but not compatible with night vision cameras.

If your Murano Z51 not equipped with ADAS, you can consider budget options. However, keep in mind: cheap glasses often have:

  • 🔍 Uneven edges (problems during installation).
  • 🔍 Poor sealing (the appearance of condensation inside the cabin).
  • 🔍 Rapid clouding of PVB film (after 1-2 years).
💡

Before buying an analogue, check it for light: hold it up to a light source - high-quality glass should not have bubbles or waves in the laminate.

When your windshield needs to be replaced: 5 critical signs

Not every glass damage requires replacement. For example, a chip with a diameter of up to 1 cm can be repaired with polymer. But there is 5 caseswhen replacement is required:

  1. Crack longer than 30 cm - even if it does not interfere with the view, over time it will move further due to vibrations.
  2. Damage in the heating zone — disrupts the functioning of the threads, which will lead to icing of the glass in winter.
  3. Chip in the rear view mirror mounting area — weakens the structure, risk of the mirror tearing off in an accident.
  4. Image distortion for ADAS camera — checked by test drive: if the system gives false warnings, the glass must be replaced.
  5. Peeling of PVB film - noticeable by rainbow stains between the layers of glass (a sign of aging or defects).

Special attention - cracks at the bottom of the glass. Due to their close location to the engine, they diverge faster due to temperature changes. If the crack reaches the edge of the glass, it cannot be repaired - only replacement!

⚠️ Attention: B Murano Z51 glass is attached to the body structural adhesive, and not a rubber seal. This means that in the event of an accident, even a slight movement of the glass can weaken the rigidity of the body by 15–20%.
How to check glass for hidden defects?

Shine a flashlight at an angle of 45° - microcracks will cast a shadow. Also, run your fingernail over the surface: if you feel snags, this is a sign that the laminate has begun to delaminate.

Step-by-step instructions for replacing a windshield with Nissan Murano Z51

Replacing glass with Murano Z51 more difficult than on most crossovers due to:

  • 🔧 Integrated rain and light sensors.
  • 🔧 Cameras ProPILOT, which cannot be removed without calibration.
  • 🔧 Reinforced adhesive seam (requires special glue SikaTack Drive).

If you decide to change the glass yourself, follow this algorithm:

☑️ Preparation for glass replacement

Done: 0 / 4
  1. Removing old glass:
    • 🛠️ Using a knife or string, cut off the old glue around the perimeter (start from the top corners).
    • 🛠️ Use suction cups for careful removal - do not pull on corners!
  2. Body cleaning:
    • 🧹 Remove any remaining glue with a spatula (do not use abrasives!).
    • 🧹 Treat the surface Sika Activator for better adhesion.
  3. Installing new glass:
    • 🔨 Apply glue SikaTack Drive solid line (thickness 8–10 mm).
    • 🔨 Install the glass, starting from the bottom edge, and press evenly around the perimeter.
  4. Assembly and calibration:
    • ⚙️ Reinstall the sensors and camera (do not turn them on until the glue is completely dry!).
    • ⚙️ Calibrate ADAS at a service station (it is impossible to do this on your own).

Time for the glue to dry completely - 24 hours. During the first 6 hours, do not open the doors (changes in pressure in the cabin can move the glass).

💡

If after replacement a whistle appears at speeds above 100 km/h, this is a sign of poor-quality sealing. Re-applying glue is required!

Calibration of ADAS systems after glass replacement: why is it necessary?

B Nissan Murano Z51 camera ProPILOT It is attached to the glass, not to the body. When replacing glass, its position shifts even by 1–2 mm, which leads to:

  • 🎯 Incorrect recognition of markings.
  • 🎯 False alarms of emergency braking.
  • 🎯 Adaptive cruise control failure.

Calibration is carried out in two stages:

  1. Static calibration (in service):
    • 📏 The car is installed on a flat area with targets.
    • 📏 Using a scanner Consult-III Plus amendments are made to the ECU.
  2. Dynamic calibration (test drive):
    • 🚗 Drive in a straight line (50–70 km/h) to set up the camera.
    • 🚗 Driving along a winding road to test the lane keeping system.

Cost of calibration in official services Nissan — 8,000–12,000 ₽. Unofficial service stations can do it cheaper (5,000–7,000 rubles), but you risk getting an error C1A50 (“Camera malfunction”).

⚠️ Attention: If after calibration the icon lights up on the instrument panel ! in a triangle, this means that the system ProPILOT disabled. Repeated procedure required!

How much does it cost to replace a windshield? Murano Z51: price analysis

The final cost depends on the type of glass, region and service. Below are the average prices in Russia (for 2026):

Service/Material Official service Unofficial service On your own
Original glass (AGC) 45 000–55 000 ₽ 40 000–48 000 ₽ 38 000–45 000 ₽
Analog (Pilkington) 35 000–40 000 ₽ 28 000–33 000 ₽ 25 000–30 000 ₽
Work (replacement + glue) 15 000–20 000 ₽ 8 000–12 000 ₽ 3,000–5,000 ₽ (glue + tools)
ADAS Calibration 8 000–12 000 ₽ 5 000–7 000 ₽ Impossible on your own
TOTAL (with original glass) 68 000–87 000 ₽ 53 000–67 000 ₽ 46 000–55 000 ₽

Where you can save:

  • 💰 Buy glass directly from dealers AGC or Pilkington (10–15% cheaper).
  • 💰 Look for promotions in services (for example, “glass replacement + calibration for 50,000 ₽”).
  • 💰 If there is no ADAS, no calibration is needed - savings of up to 12,000 ₽.

But remember: saving on glue or calibration can cost you failure of security systems or water leaks into the cabin.

Windshield care Murano Z51: how to extend its life

The average lifespan of a windshield is 5–7 years. But with proper care it can be extended up to 10 years. Basic rules:

  • 🧼 Washing: Use only contactless detergents (eg Sonax Glass Cleaner). Brushes with stiff bristles scratch the anti-reflective coating.
  • ❄️ Winter care:
    • Do not pour hot water on icy glass - temperature changes lead to microcracks.
    • Use a scraper with silicone coating (metal ones leave scratches).
  • 🚗 Parking: Place the car under a canopy or use a glass cover to protect against hail and bird droppings (their acids corrode laminate flooring).
  • 🛠️ Repair of chips: Seal damage with polymer (Permatex Windshield Repair Kit) in the first 24 hours - this will prevent the cracks from spreading.

Special attention - cleaning sensors under glass. Their contamination leads to:

  • 🔴 False alarms of light sensors (headlights turn on during the day).
  • 🔴 Failure of the automatic braking system.

To clean, use alcohol wipes (does not contain oils!). Do not rub the sensors with a dry cloth - this will scratch the lenses.

💡

Once every six months, check the tightness of the glass: in rainy weather, place a newspaper on the dashboard inside. If it gets wet, re-treatment with glue is required.

FAQ: Frequently asked questions about windshields Nissan Murano Z51

Is it possible to drive with a crack in the glass if it does not interfere with your view?

No, even a small crack is dangerous for three reasons:

  1. In the event of an accident, the glass may break and fail to support the roof (risk of injury).
  2. The crack distorts the headlights of oncoming cars, increasing eye fatigue.
  3. The owner may be fined under Part 1 of Art. 12.5 of the Code of Administrative Offenses (500 ₽) for “conditions that threaten security.”
How to distinguish original glass from a fake when purchasing?

Check:

  • 🔍 Hologram AGC in the lower left corner (counterfeits often have a blurry logo).
  • 🔍 Labeling DOT 43 and the date of production (on the original it is embossed with a laser, on the fake - with paint).
  • 🔍 Weight: the original weighs ~18 kg, fakes - 15-16 kg (thinner glass).

Also ask for a certificate of conformity ECE R43.

How long does it take to replace glass at the service?

From 3 to 6 hours, depending on complexity:

  • 🕒 Replacement without ADAS: 3–4 hours.
  • 🕒 Replacement with ADAS + calibration: 5–6 hours (including test drive).

Some services offer “express replacement” in 2 hours - this is risky, since the glue does not have time to polymerize.

Is it possible to replace glass yourself if you have no experience?

Technically yes, but:

  • ⚠️ Risk of damage to ADAS sensors (camera replacement cost - ~30,000 ₽).
  • ⚠️ Incorrect glue will lead to leaks or glass displacement in an accident.
  • ⚠️ Without calibration, driver assistance systems will not work correctly.

If you still decide, practice in another car or watch detailed video on Murano Z51.

What should I do if, after replacing the glass, noise appears at speed?

Causes and solutions:

  • 🔊 Whistling: The glass does not fit tightly. You need to reapply glue around the perimeter.
  • 🔊 Rumble: Displacement of door seals. Check for tightness and adjust if necessary.
  • 🔊 Clicks: Poorly secured rear view mirror. Tighten the fastenings.

If the noise does not disappear, contact a service center to diagnose the body (the struts may have been damaged during replacement).