<em>Nissan Note</em> rear wiper: why it doesn’t work, how to replace and care for it

Rear wiper on Nissan Note - a small but critical element that often goes unattended until it stops working at the most inopportune moment. Unlike the front wipers, the rear brush is used less often, but its operating conditions are more difficult: limited visibility, close to the glass and a high probability of freezing in winter. Owners Note (especially models E11 And E12) often encounter the fact that the wiper begins to “bounce”, leave streaks or refuses to move at all. In this article we will analyze causes of malfunctions, we will describe in detail brush and motor replacement process, and we will also give recommendations for care that will extend the life of the mechanism for years.

Feature Nissan Note - compact rear wiper with non-standard fastening (depending on the year of manufacture), which complicates the selection of spare parts. For example, for models up to 2013, brushes with a length of 280–300 mm, and for restyled versions (2013+) - 330 mm. It is also important to consider that in some trim levels Note The rear wiper works synchronously with the washer, and its failure may be due to clogged nozzles or a pump malfunction. If you notice that the wiper moves jerkily or makes squeaking noises, these are the first signs of wear. plastic bushings or drive shaftthat require immediate intervention.

Signs of a malfunctioning rear wiper Nissan Note

A rear wiper rarely breaks suddenly; the problem usually develops gradually. Here are the key symptoms that should alert you:

• 🔊 Creaking or knocking during operation - indicates wear of the plastic gears of the gearbox or lack of lubrication in the mechanism.
• 🌀 Uneven movement (twitching, stopping) - often caused by shaft corrosion or brush damage.
• 💧 Stains on glass even after several passes - a sign of wear on the rubber band or contamination of the glass.
• ❌ Full stop - may be due to a blown fuse (F35 at 10A in the cabin unit), a wiring break or motor failure.
• ⚡ Spontaneous switching on - signal about a malfunction of the relay or body electronics control unit (BCM).

If the wiper stops working after washing or rain, the likely reason is contact oxidation in the motor connector. In this case, it is enough to remove the plastic protection under the rear door and clean the terminals. But if the problem is accompanied burning smell, this means a short circuit or motor overload - diagnostics with a multimeter will be required here.

⚠️ Attention: On Nissan Note with the system Intelligent Key (keyless entry) when replacing the rear wiper, a false alarm may occur. Before work, disable the security system through the menu Settings → Security or remove the key from the sensor range.

Which brushes are suitable for Nissan Note: original vs analogues

Selecting a rear brush for Note depends on the year of manufacture and configuration. Original spare parts from Nissan have articles:

• 📌 28520-JM00A — for models 2006–2012. (length 280 mm).
• 📌 28520-JM00B - for restyled versions 2013–2020. (length 330 mm).

The cost of original brushes is from 1,200 to 1,800 rubles, but there are worthy analogues on the market:

Brand	Article	Length (mm)	Price (₽)	Features
Bosch	3397004664	330	850–1 100	Graphite coating, silent operation
Denso	WI-14B	280	700–950	UV resistant, flexible frame
Valeo	698558	300	650–800	Suitable for winter use
SWF	1128001	330	500–700	Budget option, short service life

When choosing an analogue, pay attention to fastening type: on Note system is used Hook (U-shaped hook) or Side Pin (depending on the year). Also check if it is included plastic adapter — without it, the brush may not fall into place. If you operate the machine in regions with frequent precipitation, give preference to models with silicone coating (For example, Bosch Aerotwin), which retain elasticity longer.

Step-by-step replacement of the rear wiper with Nissan Note

Replacing the rear wiper blade with Note takes no more than 10 minutes and does not require special tools. The main thing is to remove the old brush correctly without damaging the mount. Here are the detailed instructions:

1. Preparation. Raise the tailgate and make sure the wiper is in the down position. If it is locked, turn on the ignition and press the rear window washer button ("WASH" mode) to move the mechanism from its dead point.
2. Removing the old brush. Click on plastic retainer at the base of the brush (located on the side) and pull it up. If the fastener is stuck, treat it WD-40 and wait 5 minutes.
3. Installing a new brush. Align the new blade mount with the hook on the wiper arm and press until it clicks. Make sure that the latch snaps into place - otherwise the brush will fly off when you turn it on for the first time.
4. Check. Turn on the wiper mode "INT" (intermittent) and check for smooth operation. If the brush “bounces”, it means that it is installed crookedly or does not fit correctly.

If after replacement the wiper operates jerkily, the reason may lie in wear of the drive trapezoid or motor shaft corrosion. In this case, disassembly of the mechanism will be required. To access the motor you need:

Remove the plastic trim of the rear door (snap off the 4 clips)

Disconnect the motor power connector (white connector)

Unscrew the 3 motor mounting bolts (10mm wrench)

Remove the trapezoid and check the shaft play

Clean the mechanism from dirt and lubricate it with silicone grease -->

When disassembling, pay attention to condition of rubber seals - if they are cracked, they need to be replaced, otherwise moisture will get into the motor. Also check wiring for breaks: often fraying of wires occurs near the rear door hinge.

⚠️ Attention: On Nissan Note with the system Around View Monitor (360° camera) When removing the door trim, you can accidentally damage the camera connector. Before work, disconnect the battery or use plastic spatulas to remove the clips.

Rear wiper motor repair: when possible

Rear wiper motor Note It fails less often than a brush, but breakdowns still happen. Main reasons:

• 🔋 Commutator brush wear - manifests itself as uneven operation or a complete stop.
• 🧲 Winding short circuit — the wiper does not respond to the command, fuse F35 burns out.
• ⚙️ Reducer gear wear — a crunching or grinding noise is heard during operation.

In most cases, the motor can be repaired. To do this:

1. Remove the motor (as described above) and disassemble it by carefully prying the housing latches.
2. Clear collector from carbon deposits with fine sandpaper (grit 1000).
3. Check brushes - if their length is less than 5 mm, replace them with new ones (suitable for motors Valeo or Mabuchi).
4. Lubricate reducer gears lithium grease and assemble the mechanism.

If the motor winding is blackened or smells like burning, repair is pointless - replacement will be required. Cost of a new motor for Note — from 2,500 to 4,000 rubles (original 28500-JM00A). When purchasing, check that the kit includes drive trapezoid — on some analogues it has to be purchased separately.

How to check a motor with a multimeter?

Connect the probes to the motor contacts (polarity is not important). The resistance of a working winding should be within 2–5 ohms. If the device shows 0 (short circuit) or ∞ (break), the motor is faulty. Also check the current consumption: when applying 12V it should not exceed 2–3A.

Caring for your rear wiper: how to extend its service life

Average rear brush life Nissan Note - 1–2 years, but with proper care it can be increased to 3–4 years. Here are the key recommendations:

• 🧴 Regular cleaning. Once a month, wipe the rubber band of the brush with a damp cloth and soapy water. This will remove micro-particles of sand that wear away the rubber.
• ❄️ Winter preparation. Treat your brush before frost silicone grease (For example, Liqui Moly Silikon-Spray) to prevent freezing to the glass.
• 🚿 Washer control. Use only special liquid for glass (not water!). In winter, add to the tank 10–15% isopropyl alcohol to prevent freezing.
• 🔧 Checking fastenings. Once every six months, tighten the nut securing the wiper arm (the wrench is on 10) to avoid backlash.

A critical mistake many owners make is using the rear wiper on dry glass. This leads to accelerated wear of the rubber and scratches on the glass. Always turn on the washer before activating the wiper!

If you often drive on dirt roads, install on the rear window protective film (For example, 3M Scotchgard). It will reduce the abrasive effect of sand and extend the life of both the glass and the wiper.

Common mistakes when replacing and repairing

Even experienced car owners make mistakes when working with the rear wiper Nissan Note. Here are the most common:

• 🔧 Using non-original brushes of inappropriate length. For example, installing a brush on 350 mm instead of 330 mm leads to contact with the door seal and premature wear of the motor.
• 🔌 Ignoring oxidized contacts. If the wiper does not work after replacing the brush, 90% of the problems are related to corrosion in the motor connector. Clean your contacts WD-40 or DeoxIT.
• 🛠️ Tightening the lever fastening. This deforms the motor shaft and leads to play. Nut tightening torque - no more than 5 Nm.
• ⚡ Supply voltage to the motor without load. If you start the motor without the brush installed, it will burn out in a few seconds.

Another typical mistake is an attempt to “reanimate” a worn brush by trimming the rubber. This is a temporary solution that will lead to loss of downforce and deterioration of glass cleaning. If the rubber is cracked or becomes hard, the brush needs to be replaced.

⚠️ Attention: On Nissan Note with the system ProPILOT (adaptive cruise control) rear wiper is linked to camera sensors. If after repair the sign on the dashboard lights up "!" in a triangle, errors must be reset via a diagnostic scanner (for example, Launch X431).

FAQ: Answers to frequently asked questions

Is it possible to install a frameless blade on a rear wiper? Nissan Note?

Technically yes, but it's not recommended. Frameless blades do not adhere well to curved rear glass Note, which leaves uncleaned areas. The best option is original or frame brushes with double rocker (For example, Bosch Aerotwin).

Why does the rear wiper only work in one direction?

This is a sign of a problem limit switch in the motor or wire break in the trapezoid. Disassemble the mechanism and check the circuit with a multimeter. If the switch is broken, the motor will need to be replaced.

How to remove the wiper arm if the nut is stuck?

Treat the nut with penetrating lubricant (Liqui Moly LM-40) and wait 10–15 minutes. Then attach an extension (such as a pipe) to the wrench to increase leverage. If the nut does not budge, use gas burner for local heating (be careful not to damage the glass!).

What to do if the rear wiper is frozen to the glass?

Do not tear it off by force - this will damage the mechanism. Pour over the ice warm (not hot!) water with added salt or use a special defrost (Hi-Gear HG5647). After defrosting, wipe the glass and brush dry.

Where is the rear wiper fuse located? Nissan Note?

fuse F35 (10A) located in interior fuse box (under the steering wheel, on the left). To get to it, remove the cover by pressing the latches on top. Also check the relay K20 — it is responsible for the operation of the washer and wiper.

💡

If the rear wiper on a Nissan Note stops working after rain, in 80% of cases the problem lies in oxidized motor contacts or the fuse box. Start diagnostics with them!