Manual transmission Nissan Qashqai - a unit that, with proper maintenance, lasts hundreds of thousands of kilometers without repair. But many owners are faced with the question: how much oil to fill in manual transmissionwhen is it time to replace? The answer depends on the generation of the crossover, the type of box and even the year of manufacture. In this article we will analyze exact volumes for all modifications of Qashqai (J10, J11, J12), as well as the nuances of choosing transmission fluid and replacement procedures.
The manufacturer often claims that manual transmission oil is filled for its entire service life, but in practice its properties deteriorate after 80–100 thousand km. The replacement is especially relevant for cars operated in difficult conditions: towing, off-road, frequent traffic jams. If you ignore maintenance, the risk of wear of synchronizers and bearings increases significantly. Below is a detailed breakdown of the models and useful tips from the experts.
Oil volume in Nissan Qashqai manual transmission by generation
Crossover Nissan Qashqai was produced with three types of manual transmissions: RS6F92A (6-speed), FS5R30A (5-speed) and RL4R01A (4-speed, rare). The oil volume varies not only depending on the gearbox model, but also on the method of replacement - partial or complete. Below is a table with current data for the Russian market.
| Generation | Gearbox model | Volume for partial replacement (l) | Volume for complete replacement (l) | Years of manufacture |
|---|---|---|---|---|
| J10 (1st) | FS5R30A (5MT) | 2.3–2.5 | 2.8–3.0 | 2007–2013 |
| J10 (restyling) | RS6F92A (6MT) | 2.6–2.8 | 3.2–3.4 | 2010–2013 |
| J11 (2nd) | RS6F92A (6MT) | 2.7–2.9 | 3.3–3.5 | 2014–2021 |
| J12 (3rd, rare) | Modified 6MT | 2.8–3.0 | 3.4–3.6 | 2021–present |
It is important to consider that when partial replacement (draining old oil without flushing) up to 30% of the used fluid remains in the box. A complete replacement involves the use of special equipment for bleeding the system or multiple drains and fills with mileage between stages. For most owners Qashqai The first option is optimal - it is less expensive and quite effective with regular maintenance.
⚠️ Attention: In boxes RS6F92A (6MT) after 2015, 0.2–0.3 liters more oil may be required due to a modified crankcase. Check the VIN code with your dealer or in the service documentation.
What kind of oil to fill in a Qashqai manual transmission: manufacturer's recommendations
Nissan officially recommends for manual transmissions Qashqai transmission oils with viscosity 75W-80 or 75W-90compliant with the standard API GL-4. However, in practice, the choice depends on climatic conditions and driving style. For example:
- 🌡️ For regions with frosts below -30°C: synthetics 75W-80 (For example, Nissan MT-XZ Gear Oil or Mobilube 1 SHC 75W-80).
- 🏜️ For hot climates or aggressive driving: 75W-90 (For example, Castrol Syntrans Transaxle 75W-90).
- ⚙️ For gearboxes with mileage >150 thousand km: semi-synthetics with improved extreme pressure additives (for example, Liqui Moly Hochleistungs-Getriebeoil 75W-90).
It is strictly not recommended to use oils with class GL-5 — they contain sulfur-phosphorus additives that are aggressive to synchronizers Nissan. Also avoid generic fluids like ATF (for automatic transmissions) or cheap mineral oils - they do not provide adequate protection under high loads.
- Original Nissan MT-XZ
- Castrol Syntrans
- Mobilube 1 SHC
- Liqui Moly
- Other
If you are not sure about the choice, consult the car manual or use online VIN selection services (for example, Nissan Service Portal). For Qashqai J11 2018+ model year, the manufacturer can recommend oils with approval Nissan MT-XZ Premium is a modified formula with an increased resource.
How to check the oil level in a Nissan Qashqai manual transmission
Unlike automatic transmission, manual transmission Qashqai does not have a dipstick to check the oil level. Control is carried out through filler pluglocated on the gearbox housing. You will need:
- Place the car on a flat surface (lift or inspection pit).
- Clean the area around the filler plug from dirt (to prevent debris from getting inside).
- Unscrew the plug with the key to
24 mm(on some models - on17 mm). - The oil level should be at the edge of the hole. If the liquid is not visible, topping up is required.
If the oil has a dark color, an unpleasant odor, or metal particles are visible in it, this is a signal for a complete change. Also pay attention to the condition of the filler plug O-ring: if it is worn, replace it to prevent leaks.
Warm up the box (drive 5–10 km)
Turn off the engine and wait 5 minutes
Prepare a 24 mm wrench and a container for draining
Clean the gearbox housing from dirt -->
⚠️ Attention: Do not check the oil level immediately after a trip - the liquid should drain into the crankcase. Optimal box temperature for testing: 30–40°C (warm, but not hot).
Step-by-step instructions for changing the oil in a Qashqai manual transmission
Changing the oil in a manual transmission Nissan Qashqai - a procedure that can be performed independently if you have the tools. You will need:
- 🔧 Keys on
10 mm,17 mmAnd24 mm(or a head with a knob). - 🛢️ New oil (see the table above for volume).
- 🔩 New drain plug with O-ring (item no.
32036-31X01for J10/J11). - 🧹 Rags, drainage container (minimum 4 l), funnel with flexible hose.
Procedure:
- Warm up the box (drive 10–15 km) so that the oil becomes less viscous.
- Drive the car onto a pit or lift. Remove the crankcase protection (if equipped).
- Place a container under the drain hole (located in the lower part of the gearbox housing).
- Unscrew the drain plug with a wrench
17 mmand drain the oil. Be careful - the liquid is hot! - Screw in the drain plug with a new gasket (tightening torque -
30–35 Nm). - Unscrew the filler plug (key on
24 mm) and use a funnel to fill in new oil up to the edge of the hole. - Tighten the filler plug and take it for a test drive. Check for leaks.
If you are doing complete replacement, after draining the old oil, fill in new oil, then drive 500–1000 km and repeat the procedure. This will help flush out any remaining waste fluid.
For ease of filling, use a hose from a dropper - it is flexible and allows you to direct the oil exactly into the hole without spills.
Common mistakes when changing oil in a manual transmission
Even experienced car owners sometimes make mistakes that can lead to box failure. Here are the most common:
- 🔄 Incorrect oil volume: Overfilling or underfilling impairs gear lubrication and can cause leaks through the seals.
- 🛑 Using the wrong type of oil: for example,
GL-5instead ofGL-4leads to corrosion of synchronizers. - 🔧 Loose drain plug: Leaks are often caused by an old seal or insufficient tightening torque.
- 🌡️ Replacement without warming up the box: cold oil does not drain completely, remaining in the crankcase cavities.
Another typical problem is ignoring the state gearbox breather (ventilation valve). If it is clogged, excess pressure is created inside the box, which leads to oil being squeezed out through the seals. Clean the breather (located next to the fill plug) every time you change the oil.
What happens if you pour oil into a manual transmission?
Excessive oil volume leads to foaming of the fluid, which impairs lubrication and increases the load on the seals. As a result, leaks may appear, as well as accelerated bearing wear due to an insufficient lubricant film on the parts.
When to change the oil in a Nissan Qashqai manual transmission: regulations and signs of wear
Official regulations Nissan does not provide for changing the oil in the manual transmission throughout the entire service life of the vehicle. However, in practice, this rule only applies to ideal operating conditions, which practically do not exist in Russia. Recommended intervals:
- 📅 Standard terms: every 80–100 thousand km or 5 years (whichever comes first).
- ⚠️ Difficult conditions (off-road, towing, city traffic jams): every 50–60 thousand km.
- 🔧 After gearbox repair: An oil change is required regardless of mileage.
Signs that it's time to change the oil:
- 🔊 Crunching or grinding noise when changing gears.
- 🛑 Difficulty turning on speeds (especially when cold).
- 💨 Unpleasant burning smell from oil (signals overheating).
- 🎯 The appearance of vibrations or extraneous noise in the box.
If you notice any of these symptoms, do not delay diagnosis. In some cases (for example, when water gets into the box), the oil needs to be changed immediately, regardless of mileage.
Even if you drive a little, the oil in a manual transmission ages over time - it oxidizes and loses its properties. Therefore, replacement by period (5 years) is no less important than by mileage.
Answers to frequently asked questions (FAQ)
Is it possible to mix different oils in a Qashqai manual transmission?
Mixing oils of different brands or types (for example, 75W-80 And 75W-90) is not recommended as it may cause foaming or loss of lubricity. An exception is adding a small amount (up to 10%) of oil of the same manufacturer and viscosity in emergency cases. Perform a complete replacement as soon as possible.
What to do if the gears are difficult to engage after changing the oil?
This can be caused by several reasons:
- Incorrect type of oil (eg too thick for low temperatures).
- Air entering the system (you need to run the gearbox in idle gears).
- Wear of synchronizers (transmission diagnostics required).
If the problem does not disappear after 200–300 km, contact service.
Is it necessary to flush the manual transmission when changing the oil?
Flushing the manual transmission Nissan Qashqai required only in cases:
- Severe oil contamination (metal shavings, sediment).
- Switching to a different type of oil (for example, from mineral to synthetic).
- Water or fuel gets into the box.
For washing, use special compounds (for example, Liqui Moly Getriebe-Reiniger) or oil of the same viscosity as the base oil. After washing, be sure to replace the filter (if your gearbox model has one).
What kind of oil is poured into the Qashqai manual transmission from the factory?
On the conveyor belt into boxes Nissan Qashqai original oil is poured Nissan MT-XZ Gear Oil 75W-80 (article KE916-99932). This is a synthetic fluid with a package of additives optimized for synchronizers Nissan. Analogues: Mitsubishi DiaQueen MTF 75W-80 or Ravenol MTF-2 75W-80.
Is it possible to drive with a manual transmission oil leak?
Absolutely not. Even a small leak leads to a decrease in oil level, which can lead to:
- Accelerated wear of bearings and gears.
- Overheating of the box due to insufficient lubrication.
- Jamming of the gearbox (in critical cases).
If a leak is detected, immediately check the oil level and eliminate the cause (most often it is a worn plug gasket or drive oil seal).