Windshield size <em>Nissan Qashqai J10</em> (2006-2013): complete guide to selection and replacement

Windshield Nissan Qashqai J10 (first generation, 2006–2013) is a critical element that affects not only visibility, but also the safety of the vehicle. Its replacement may be required after mechanical damage, cracks or manufacturing defects, but before purchasing new glass you need to know exactly its dimensions, part numbers and fastening features. In this article we will analyze all the nuances: from standard dimensions to the subtleties of choosing between the original and analogues.

First generation Qashqai (index J10) was produced in different modifications - with air conditioning, climate control, rain and light sensors, which affects the design of the glass. For example, models with rain sensor require glass with a special area for its installation, and versions with heating — with integrated heating filaments. Inconsistency of these parameters will lead to incorrect operation of the systems or impossibility of installation.

The article will be useful to both owners Qashqai J10, and for car service technicians. We have collected current data on articles, sizes, manufacturers and will give practical advice on replacement - from dismantling to installing new glass with sealing.

Standard windshield sizes Nissan Qashqai J10

Windshield dimensions for Qashqai J10 unified for all bodies (including versions with panoramic roof), but may vary slightly depending on the configuration. Main parameters:

• 📏 Height: 1050–1060 mm (depending on year of manufacture and options).
• 📐 Width: 1430–1440 mm (outer edges).
• 🔳 Thickness: 4.5–5.5 mm (standard for laminated glass).
• 🖼️ Bend radius: individual for each batch, but compatible with original seals.

Important: even if the sizes match, the glass may not fit if the dimensions are not taken into account holes for mounting the rear view mirror or rain sensor probe. For example, glass for versions with Bose audio system have enhanced sound insulation and differ in weight.

For an accurate selection, use VIN code car or check the article for compatibility through manufacturer catalogs (for example, Pilkington, Saint-Gobain Sekurit). Below is a table with original articles and their analogues.

Original articles and analogues of glasses for Qashqai J10

Manufacturer	Article	Applicability	Features	Average price, ₽
Nissan (original)	28510-JM00A	All modifications of J10 (2006–2013)	With rain sensor, heating	22 000–25 000
Pilkington	NN 28510 JM00A	Analogue of the original	Without rain sensor (needs improvement)	14 000–16 000
Saint-Gobain Sekurit	703506	For versions with climate control	Enhanced tinting of the top edge	16 000–18 000
XYG (China)	NQJ10-01	Budget option	Without heating, optical defects are possible	8 000–10 000

⚠️ Attention: When purchasing analogues, check availability certificate of conformity (For example, ECE R43). Glass without markings may not withstand the impact of an accident and crumble into sharp fragments.

If your Qashqai J10 equipped 360-degree camera (optional for top-end trims), look for glass with a hole for its fastening. Otherwise, you will have to drill new glass, which can lead to cracks.

How to determine the glass size on your Qashqai J10

If you are not sure about the article number or year of manufacture of the car, you can measure the glass size yourself. To do this:

1. Remove the rubber seal around the perimeter of the glass (carefully so as not to damage it).
2. Measure visible part of the glass (excluding the area hidden under the panel) with a tape measure or ruler.
3. Check availability markings in the lower corner of the glass (usually on the left side). The manufacturer's code and date of manufacture are indicated there.

📌 Key Point: U Qashqai J10 with panoramic roof the glass has a reinforced top edge (up to 6 mm thick). If you install regular glass, it may break when driving over uneven surfaces.

To check compatibility, use online catalogs:

• 🔍 Official Nissan catalog (by VIN code).
• 🔍 Autodoc (filter by model and year).
• 🔍 EXIST (for professional workshops).

Step-by-step instructions for replacing a windshield

Replacing glass with Qashqai J10 Requires care and special tools. If you have never performed such work, it is better to contact a car service. To replace it yourself, prepare:

• 🔧 A set of plastic spatulas for removing the seal.
• 🧴 Glass sealant (for example, 3M Windshield Urethane).
• 🔪 String or wire for cutting old glue.
• 🧽 Degreaser (acetone or alcohol).

⚠️ Attention: Do not use metal tools to remove glass - they will damage the paint on the body. Also avoid heating the glass with a hairdryer: laminated glass may delaminate.

Make sure that the new glass matches the article number|

Remove the wipers and the plastic trim under the glass|

Disconnect the battery (to avoid short circuit when working with sensors)|

Prepare a warm room (temperature not lower than +15°C)-->

Replacement process:

1. Remove the rubber seal and moldings around the perimeter of the glass.
2. Cut away the old caulk with a string, starting from the top corner.
3. Carefully remove the glass (better with an assistant - it is heavy!).
4. Clean the seat from any remaining glue and degrease the surface.
5. Apply new sealant to the body and install the glass, pressing it evenly.
6. Secure the glass with tape for 2-3 hours to allow the glue to polymerize.

After replacement, do not wash the car or open the doors forcefully for 24 hours - this may dislodge the glass until the sealant has completely dried.

What should I do if the glass cracks after installation?

If a crack appears immediately after replacement, the reasons may be as follows:

1) Incorrect centering of the glass during installation (misalignment).

2) Use of low-quality sealant or its uneven application.

3) Excessive force when tightening moldings.

In this case, the glass is subject to warranty replacement (if the work was performed by a service center).

Common mistakes when replacing glass with Qashqai J10

Even experienced craftsmen sometimes make mistakes that lead to leaks or squeaks. Here are the most common:

• 🚫 Ignoring the rain sensor: If the new glass does not have an area for the sensor, it will have to be glued separately, which will impair the accuracy of the work.
• 🚫 Savings on sealant: Cheap analogues may crack after a year, which will lead to water leaks into the interior.
• 🚫 Improper drying: If the car is taken out into the cold immediately after replacement, the sealant will not polymerize evenly.

🔹 How to avoid problems:

1. Check glass compatibility according to VIN code, and not just by model.
2. Use sealant with markings DOW BETASEAL or SikaTack.
3. After installation, check the operation of the wipers - they should not cling to the edge of the glass.

If after replacement there is creaking when movingMost likely, the glass did not fit tightly enough to the body. Solution: dismantle and reinstall with a new layer of sealant.

Windshield replacement cost: service vs do it yourself

Glass replacement price Qashqai J10 varies depending on region and type of glass:

Glass type	Cost of glass, ₽	Cost of work (service), ₽	Total, ₽
Original (with rain sensor)	22 000–25 000	5 000–7 000	27 000–32 000
Pilkington (analog)	14 000–16 000	4 000–6 000	18 000–22 000
Budget (XYG)	8 000–10 000	3 000–5 000	11 000–15 000

💡 Advice: If you decide to change the glass yourself, buy replacement kit (includes sealant, primer and spatulas) - this will save time and nerves. The average cost of such a kit: 2,500–3,500 rubles.

Be sure to check with the service whether the price includes:

• 🔧 Rain sensor calibration (if applicable).
• 🧹 Removing fragments from the interior.
• 📝 Labor warranty (usually 6-12 months).

FAQ: Frequently asked questions about windshields Nissan Qashqai J10

Is it possible to drive with a crack in the windshield?

If the crack does not interfere with your view and is not in the wiper operating area, you can drive, but:

• 🚗 In an accident, glass may crumble, which will lead to injury.
• 📜 The insurance company may refuse to pay if the crack was there before the accident.
• 💧 In the rain, the crack will scatter the headlights of oncoming cars, worsening visibility.

We recommend replacing the glass as soon as possible.

Which sealant is best to use for Qashqai J10?

Optimal options:

• 3M Windshield Urethane — dries quickly, resistant to vibrations.
• SikaTack Drive - Suitable for cold climates.
• Dow Betaseal 1527 — original sealant used on the Nissan assembly line.

Avoid cheap, unlabeled analogues ECE R43.

What is the difference between the glass for versions with a panoramic roof?

Glass for Qashqai J10 with panoramic roof have:

• 🔹 Reinforced top edge (thickness up to 6 mm versus standard 4.5 mm).
• 🔹 Additional layer of tinting in the upper part (for protection against UV rays).
• 🔹 Changed geometry of attachment to the body (different angle).

Installing regular glass on this version will lead to leaks and squeaks.

Is it possible to tint the windshield on Qashqai J10?

According to the law of the Russian Federation, tinting the windshield is prohibited (except for the top strip no more than 14 cm). However, some owners apply transparent protective film (For example, LLumar), which:

• 🛡️ Protects against chips.
• 🌞 Reduces interior heating.
• 🚗 Does not impair visibility (transparency 90%+).

This film is legal and recommended for protection against gravel.

How to check whether the original glass is installed?

Signs of original glass Nissan:

• 🏷️Marking Nissan or ASahi Glass in the bottom corner.
• 🔍 No optical distortion (checked with a laser level).
• 📏 Exact match with seals (no gaps).
• 💧 Logo ECE R43 — confirmation of certification.

Analogues often lack the production date or only indicate the country (for example, “Made in China”).