Nissan Note E11 bolt pattern: how to choose the right wheels and tires

Selection of rims and tires for Nissan Note E11 (2006–2013) is a task that requires attention to technical details. Error in bolt pattern parameters (PCD) or departure (ET) can lead to vibrations, accelerated wear of the suspension or even accidents. In this article we will analyze all the key characteristics: from standard values ​​to permissible deviations for tuning.

Model Note E11 was produced with different engines and configurations, but the wheel mounting parameters remained unchanged. However, even here there are nuances: for example, discs from later versions Note E12 may not fit due to differences in hub hole diameter (DIA). We have collected current data, verified in practice, and added tips from auto mechanics.

What is a bolt pattern and why is it important for Nissan Note E11

Bolt pattern (or PCD — Pitch Circle Diameter) is the diameter of the circle on which the wheel rim mounting holes are located. For Nissan Note E11 this parameter is fixed: 4×100 (4 holes, distance between opposite ones - 100 mm). A deviation of even 1–2 mm will lead to the fact that the disc will not fit tightly on the hub, and the nuts will be tightened skewed.

Consequences of incorrect bolt pattern:

• 🔧 Steering wheel vibration at speeds above 80 km/h due to imbalance.
• 🚗 Accelerated wear wheel bearings and ball joints.
• 💥 Unscrewing the nuts in motion (in critical cases).

In addition to PCD, other parameters are also important:

• 📏 Departure (ET) — the distance from the mating plane of the disk to its center. For Note E11 standard departure - ET45.
• ⭕ Hub Bore Diameter (DIA) - must match the diameter of the car hub (at Note E11 — 66.1 mm).
• 🔩 Thread of mounting nuts/bolts - usually M12×1.25.

Standard wheel parameters for Nissan Note E11 by year and trim level

Despite a single chatter 4×100, factory wheels for Note E11 varied in size depending on the market and configuration. Below is a table with the original parameters:

Year of manufacture	Equipment	Tire size	Disk size	Departure (ET)
2006–2008	Base / Comfort	175/65 R15	5.5J×15	ET45
2009–2010	Tekna / Acenta	185/55 R16	6J×16	ET45
2011–2013	All versions	175/60 R16	6J×16	ET45

Please note: discs 6J×16 ET45 from later versions are also suitable for earlier models, but the tires 185/55 R16 may touch the arches when the car is fully loaded. Before purchasing, check clearances using drawdown test: Load the machine to maximum and spin the wheels by hand.

⚠️ Attention: Discs with offset ET38–40 visually look more aggressive, but increase the load on the wheel bearings. For daily use, it is recommended to stick to the factory settings. ET45.

Which wheels are suitable for Nissan Note E11: original vs analogue

Original wheels from Nissan (items start with 40500- or 40510-) guarantee 100% compatibility, but their price is often too high. An alternative is disks from other manufacturers with the same parameters. The main thing is that they have a certificate TÜV or JWL (Japanese standard).

Proven analogue brands:

• 🏭 Enkei — lightweight alloy wheels, suitable for tuning.
• 🔧 BBS - premium segment, but require careful handling (soft alloy).
• 🚗 Kosei — optimal price/quality ratio for Note E11.
• 💰 Replica - budget copies of original discs (for example, from Nismo).

When choosing analogues, consider:

1. Material: cast discs are lighter than stamped ones, but withstand impacts less well. Forged - the most durable, but expensive.
2. Centering rings: if the disk DIA is larger 66.1 mm, plastic adapters will be required.
3. Warranty: discs without a certificate may crack at the first strong impact.

Tires for Nissan Note E11: sizes, pressure and seasonality

Factory tire sizes for Note E11 — 175/65 R15 or 185/55 R16. But other options are also allowed if they do not go beyond the permissible diameter deviations. For example, 195/50 R16 will do, but the speedometer will overestimate the speed by 2–3%.

Recommended tire pressure:

• 🚘 Front wheels: 2.2–2.3 bar (depending on load).
• 🚙 Rear wheels: 2.0–2.1 bar (at full load up to 2.4 bar).

When choosing tires, consider:

• ☀️ Summer: To save fuel, models with low rolling resistance are suitable (for example, Michelin Energy Saver).
• ❄️ Winter: Studded tires perform better on ice, but reduce comfort. Friction (“Velcro”) is a compromise for the city.
• 🔄 All-season: Not recommended for regions with harsh winters (lose properties at -15°C).

⚠️ Attention: Tires with a lower speed index T (190 km/h) not suitable for Note E11, even if you don't plan to drive fast. When driving for a long time at high speeds (for example, on the highway), they overheat and may burst.

How to read tire markings?

Example: 185/55 R16 83H

- 185 — profile width in mm.

- 55 — profile height in % of width.

- R16 - radial design, diameter 16 inches.

- 83 — load index (487 kg per wheel).

- H — speed index (up to 210 km/h).

Tuning wheels on Nissan Note E11: do's and don'ts

Many owners Note E11 want to give the car a sporty look with larger diameter wheels. However, there are strict limitations:

Valid options:

• 🔄 Discs 7J×17 ET40 with tires 205/40 R17 - require rolling out the arches.
• 🔧 Discs 6.5J×16 ET38 with tires 195/50 R16 — minimal changes in handling.

Prohibited options:

• ❌ Discs R18 and higher - lead to damage to the suspension.
• ❌ Less flight ET35 — the wheels will cling to the arches.
• ❌ Tires wider than 205 mm - increase fuel consumption and load on the steering rack.

Before installing non-standard wheels, be sure to:

1. Check clearances using ruler or caliper.
2. Test the car for training ground (for example, in a parking lot with bumps).
3. Balance the wheels with weights on the inside (for discs with deep overhang).

Common mistakes when choosing wheels and how to avoid them

Even experienced car owners sometimes make mistakes when choosing wheels for Nissan Note E11. Here are the most common mistakes:

1. Ignoring DIA: Disc with hole 67.1 mm (for example, from Toyota) will not fit on the hub Note without centering rings. Consequence - steering wheel beating at speed.
2. Incorrect departure: Discs with ET30 may look stylish, but reduce the life of the pendant by 30-40%.
3. Savings on balancing: Even a new disk requires balancing. Unbalanced wheel at speed 100+ km/h creates a load equivalent 300 kg to the bearing.

How to avoid mistakes:

• 📋 Always check the parameters with driver's door sticker (acceptable sizes are indicated there).
• 🔍 Buy discs only from trusted stores (for example, Kolesa-Darom or BlackTyres).
• 🛠️ After installing new wheels, do wheel alignment - even if the geometry has not changed.

Where to buy wheels and tires for Nissan Note E11: trusted stores

When purchasing wheels for Note E11 It is important to choose a reliable seller. We recommend the following options:

Store type	Examples	Pros	Cons
Official dealers	Nissan Center, Auto special center	Original parts guarantee	High price, limited range
Online hypermarkets	Kolesa-Darom, BlackTyres	Wide selection, promotions	Risk of running into a fake
Local tire shops	Small service stations with their own warehouses	You can try on before buying	Prices are higher than online

When purchasing online, be sure to:

• 📄 Demand photo of real product (not a catalog).
• 📦 Check packaging — original discs have holograms and serial numbers.
• 💳 Pay upon receipt (cash on delivery).

If you buy used wheels, pay attention to:

• 🔍 Cracks near the mounting holes.
• 🛠️ Chips on the inside (evidence of strong impacts).
• 🧲 Magnet - if it does not attract, the disk is aluminum (fragile).

FAQ: Answers to frequently asked questions about the Nissan Note E11 bolt pattern

Is it possible to install wheels from Nissan Micra K13 on Note E11?

Yes, but only if they are models with a bolt pattern 4×100 And DIA 66.1 mm. For example, disks from Micra K13 included Acenta (2010–2016) will fit without modifications. However, the offset may differ: Micra common ET40, which will lead to a slight movement of the wheels outward.

What happens if you install disks with PCD 4x114.3?

Such disks (for example, from Honda Civic) cannot be physically secured: the holes will not align with the hub screws. Even if you drill new holes, this will weaken the disc and make it dangerous to use. The only way out is to use PCD adapters, but it is illegal in most countries (including Russia).

What is the maximum offset deviation (ET) allowed?

For Nissan Note E11 safe range - ET42–48. Departure ET40 and below requires the installation of spacers, and ET50+ may cause the disc to rub against the brake caliper. Check the clearances on the lift!

Is it possible to install tires with a profile height of less than 55%?

Technically yes, but this will reduce comfort and increase the risk of damage to the discs in the pits. For example, tires 195/45 R16 visually look sportier, but when hitting a pothole at speed 60+ km/h there is a high probability of bending the disc. The optimal minimum for Note E11 — 50% (For example, 195/50 R16).

How often should the bolt pattern be checked during operation?

Check the tightness of nuts/bolts every 10,000 km or after strong impacts (for example, falling into a hole). Use torque wrench with the moment 90–110 Nm. If you notice that the nuts are coming loose more than once a season, this is a sign of a misaligned PCD or worn hub threads.