2011 <em>Nissan Juke</em> Fuses: Complete Guide with Diagrams and Replacement Tips

Nissan Juke 2011 is a compact crossover that has gained popularity due to its unusual design and dynamic characteristics. However, like any car, it requires regular maintenance, including checking and replacing fuses. These small but critical elements protect electrical circuits from overloads and short circuits, preventing serious damage.

If your headlights, windshield wipers, audio system, or other electrical components stop working, the first thing to do is check the fuses. In this article we will take a closer look at where the fuse boxes are located in Nissan Juke 2011 model year, their purpose, and also give step-by-step instructions for replacement. You will also learn how to correctly diagnose faults and avoid common mistakes when working with car electrical equipment.

Where are the fuse boxes located in Nissan Juke 2011

B Nissan Juke 2011 has two main fuse boxes:

• 🔧 Main unit — located in the car interior, under the instrument panel on the driver’s side. To access it, you need to open the driver's door and remove the decorative cover.
• 🚗 Additional block — located in the engine compartment, next to the battery. This block is responsible for high power fuses such as the generator, starter and injection system circuits.

There may also be a third, less noticeable block in the car - relay block, which is often located next to the main fuse box in the passenger compartment. Its purpose is to control powerful electrical consumers such as cooling fans, fuel pump and headlights.

It is important to note that the location of the blocks may vary slightly depending on the vehicle configuration. For example, in versions with Nissan Juke Nismo or Juke RS blocks can be moved to optimize space under the hood.

Interior block fuse diagram Nissan Juke 2011

The interior fuse box contains most of the elements responsible for the operation of the vehicle's internal equipment. Below is a table with the purpose of each fuse, its rating and protected circuits.

Fuse no.	Denomination (A)	Purpose	Notes
1	10	Audio system, navigation	Also responsible for the USB port and Bluetooth module
5	15	Cigarette lighter, 12V socket	Often fails when using powerful devices
10	7.5	ABS sensors, stability control system	When burned out, the indicator lights up ABS on the dashboard
14	10	Windshield wipers, windshield washer	Also controls the operation of the rear windshield wiper (if equipped)
20	15	Heated seats, mirrors	May burn out if all heating elements are turned on simultaneously

A complete fuse diagram for your configuration can be found in instruction manual (section 8-30 for European versions or 9-28 for American ones). If you do not have a paper manual, you can download it from the official website Nissan or on specialized forums such as Nissan Club Russia or Juke Owners Forum.

⚠️ Attention: Never replace fuses with elements with a higher rating than indicated in the diagram. This can lead to overheating of the wiring and even a fire. If the fuse constantly blows, this indicates a fault in the circuit and requires diagnosis by an electrician.

Engine compartment fuse diagram

Engine compartment fuse box Nissan Juke 2011 is responsible for critical vehicle systems. Here are the higher rated fuses (from 20 to 100 A) that protect the circuits:

• ⚡ Generator and starter - fuses for 80–100 A.
• 🔥 Fuel injection systems - usually 15–20 A.
• 💡 Main relay and engine control unit (ECU) — 10–15 A.
• 🚨 Security systems (immobilizer, alarm) — 7.5–10 A.

A feature of the engine compartment block is the presence fuse links (fusable links), which perform the same function as fuses, but are designed for higher currents. Replacing them requires care, as they are often integrated into wiring harnesses.

Fuse no.	Denomination (A)	Purpose	Symptoms of a problem
A	100	Generator main relay	The battery is not charging, the indicator light is on BATT
B	40	Electric cooling fan	Engine overheating, fan does not turn on
C	30	Fuel pump	The engine does not start or stalls when driving
D	20	ABS control unit	ABS sensors do not work, the lamp on the dashboard is on

In the engine compartment, fuses are often labeled with letters rather than numbers. This is due to the fact that their number is smaller, but the denominations are higher than in the salon unit. Before replacing, be sure to disconnect the battery by removing the negative terminal to avoid short circuit.

How to check and replace a fuse: step-by-step instructions

Replacing a fuse is a simple procedure but requires attention to detail. Here is a step-by-step algorithm:

1. Turn off the ignition and make sure all electrical appliances are turned off.
2. Find the faulty fuse according to the scheme (see previous sections).
3. Remove the fuse using special tweezers (usually included with the block) or small pliers.
4. Check it visually - a blown fuse has a broken thread inside.
5. Install a new fuse the same denomination.
6. Check circuit operationby turning on the appropriate equipment.

If the fuse blows again after replacement, this indicates short circuit or increased load in the chain. In this case, professional diagnosis is required.

Turn off the ignition and all electrical appliances|

Check the rating of the new fuse|

Use tweezers to remove|

Inspect the block contacts for oxidation -->

⚠️ Attention: Some fuses in Nissan Juke 2011 (for example, those responsible for ECU or ABS) can be hidden under additional covers. Do not force them out as this may damage the unit.

Typical problems with fuses in Nissan Juke 2011

Owners Nissan Juke 2011s often encounter several common fuse-related problems:

• 🔌 Frequently blown cigarette lighter fuse (F5, 15A) - usually caused by the use of powerful devices (for example, car refrigerators or compressors). Solution: use a protected power strip or connect devices directly to the battery.
• 💡 Windshield wiper fuse blown (F14, 10A) - may be due to motor jamming or contact oxidation. Check the windshield wiper mechanism for sticking.
• 🚗 Problems with the fuel pump fuse (F-C, 30A) - if it burns out, the engine will not start. The cause may be a faulty pump or damaged wiring.

Another common problem is contact oxidation in fuse blocks. This leads to poor contact and spontaneous shutdown of the circuits. For prevention, it is recommended to clean contacts once a year with a special spray (for example, CRC Contact Cleaner).

How to choose quality replacement fuses

Not all fuses are created equal. For Nissan Juke 2011, it is recommended to use original spare parts or certified analogues. Here's what to look for:

• 🏷️ Denomination - must exactly correspond to what is indicated in the diagram. For example, if a 10A fuse is required, do not install a 15A "just in case."
• 🔍 Fuse type - in Juke standard size fuses are used ATO/ATC (miniature knife ones). Some circuits may require Mini or Maxi fuses.
• 🏭 Manufacturer - give preference to brands Bussmann, Littlefuse or Nissan OEM. Avoid cheap Chinese analogues.

When purchasing, pay attention to the packaging - high-quality fuses are sold in sealed blisters with rating markings. If the fuse is sold in bulk without packaging, there is a high risk of running into a counterfeit.

There are also fuses with indicator, which glow when burned out. They are convenient for diagnostics, but are more expensive than usual. Example: Littlefuse FLMN or Bussmann LPN-RK.

Frequently asked questions about fuses Nissan Juke 2011

Is it possible to replace the fuse with a bug (wire) in an emergency?

No, it is absolutely not recommended. The "bug" has no protective properties and can lead to overheating of the wiring or even a fire. As a last resort, use a fuse with smaller rating than required (for example, 10A instead of 15A), but only as a temporary solution until the correct one is purchased.

Why does it blow again after replacing the cigarette lighter fuse?

This indicates short circuit in a circuit or increased load. Common reasons:

• Damaged wiring under the dashboard.
• Malfunction of the cigarette lighter socket (for example, shorted contacts).
• Use of devices with consumption >120 W (for example, car refrigerators).

Solution: Check the circuit with a multimeter or contact an auto electrician.

Where can I download the fuse diagram for my configuration? Nissan Juke?

The official diagram can be found:

• B instruction manual (section "Electrical equipment").
• On the website Nissan in section Owner Resources (required to enter VIN).
• On the forums: Nissan Club Russia, Juke Forum UK, Drive2.ru (search by model and year).

If you have Juke with non-standard equipment (for example, Nismo), it is better to check the diagram with the dealer.

How to check a fuse without removing it from the block?

With multimeter in circuit test mode (Ω):

1. Turn off the ignition.
2. Connect the probes to the fuse contacts.
3. If resistance 0 ohm - the fuse is OK. If ∞ (infinity) — burned out.

You can also use voltage tester: With the ignition on, check for 12V on both contacts. If there is voltage on one contact and not on the other, the fuse is faulty.

What should I do if, after replacing the fuse, the equipment still does not work?

Possible reasons:

• 🔌 The equipment itself is faulty (for example, a headlight bulb has burned out).
• 🔧 Relay problem — check the corresponding relay in the block.
• 📉 Broken wiring or oxidation of contacts.
• 🖥️ Control unit failure (For example, BCM or ECU).

For diagnosis you will need error scanner (For example, Launch X431) or help from an auto electrician.