<em>Nissan Tiida C11</em>cigarette lighter fuse: location, rating and replacement

Cigarette lighter in Nissan Tiida C11 (2007–2012) - one of the most popular elements of a car’s electrical network. Navigators, DVRs, chargers and even compressors are connected through it. But what to do if the cigarette lighter suddenly stops working? In 90% of cases the problem lies in a burnt out fuse - a small but critical element that protects the circuit from short circuits and overloads.

This article will help you figure out where the cigarette lighter fuse is located in Tiida C11, how to check and replace it without contacting service. We will look in detail at fuse block diagrams, ratings, typical diagnostic errors and give practical advice on troubleshooting. We will pay special attention hidden nuances of the Tiida C11 design, which even experienced car owners often miss.

Where is the cigarette lighter fuse located in Nissan Tiida C11

B Nissan Tiida C11 The cigarette lighter fuse is located in interior fuse box, which is located to the left of the steering column, behind the plastic cover. To access it:

1. Open the driver's door and sit in the seat.
2. Look at the panel to the left of the steering wheel - there you will see a small plastic cover with the inscription FUSE or fuse pictogram.
3. Gently pry the cover with your finger or a flathead screwdriver and remove it.

Under the cover you will find a fuse and relay box. Cigarette lighter fuse Tiida C11 usually designated as CIGAR or PWR OUTLET (depending on the year of manufacture and configuration). Its denomination is 15A (yellow). In some versions of the car there may be a fuse on 20A (yellow with a transparent insert), but this is rare.

Fuse box diagram and symbology

Fuse box in the passenger compartment Nissan Tiida C11 contains about 30–40 elements, and finding the right one among them can be difficult. Below is a table with a breakdown of the key fuses associated with the cigarette lighter and 12V socket (if you have one).

Fuse number	Denomination (A)	Purpose	Color
15	15	Cigarette lighter (CIGAR)	Yellow
16	15	12V socket (PWR OUTLET)	Yellow
20	10	Audio system (AUDIO)	Red
25	10	Dashboard lighting	Red
30	20	Heated seats (if equipped)	Yellow with transparent

Please note: some versions Tiida C11 (for example, for Asian or American markets) the location of the fuses may vary. If there is no diagram on the block cover, we recommend downloading official instruction manual for your VIN code.

⚠️ Attention: Do not confuse the cigarette lighter fuse (CIGAR) with 12V socket fuse (PWR OUTLET)! In some configurations they are separated, and replacing one will not restore the operation of the other.

How to check the cigarette lighter fuse: step-by-step instructions

Before replacing the fuse, you need to check it. To do this you will need:

• 🔧 Tweezers or a special fuse puller (usually included with the car).
• 🔦 Flashlight (for a better view).
• 📱 Multimeter or tester (optional, but recommended).

Verification algorithm:

Find the fuse CIGAR (15A) in the block|Remove it with tweezers, without using excessive force|Inspect for broken thread inside|Check with a multimeter in continuity mode (should beep)|Install a new fuse if the old one is blown-->

If you don’t have a multimeter at hand, you can check the fuse visually: a burnt-out thread inside will be torn or melted. However, this method is not always reliable - sometimes the break is not visible to the naked eye.

If the fuse is intact, but the cigarette lighter does not work, the problem may lie in:

• 🔌 Malfunctions of the cigarette lighter itself (oxidation of contacts, broken wire).
• 🔋 Discharged battery or poor ground contact.
• 🔌 Damage to the wiring from the fuse box to the cigarette lighter.

Typical mistakes when replacing a fuse

Even something as simple as replacing a fuse can be done incorrectly. Here are the most common mistakes owners make Nissan Tiida C11:

1. Using the wrong fuse rating. Installing a 20A or 25A fuse instead of a 15A fuse is fraught with melting of the wiring or even a fire. Always use original fuses marked 15A.
2. Replacing the fuse without turning off the ignition. Although in most cases this does not lead to serious consequences, it is better to be on the safe side and turn off the ignition before working with electrical equipment.
3. Ignoring the cause of burnout. If the fuse is blown, there is an overload or short circuit in the circuit. A simple replacement without finding the cause will lead to repeated failure.
4. An attempt to "repair" the fuse. Some car owners try to restore a burnt-out thread using a soldering iron or foil. This is extremely dangerous and may cause a fire!

⚠️ Attention: If the cigarette lighter sparks or gets hot after replacing the fuse, immediately unplug it and check the circuit for a short circuit. B Tiida C11 The cigarette lighter wiring goes through a relay, which can also fail.

What to do if the fuse is intact but the cigarette lighter does not work

If the test shows that the fuse is good, but the cigarette lighter still does not function, the problem may be as follows:

Diagnosis of cigarette lighter faults

1. Oxidation of contacts. Over time, the cigarette lighter contacts oxidize, especially if moisture gets into the socket. Try cleaning them with alcohol or a special contact cleaner.

2. Broken wire. The wiring from the fuse box to the cigarette lighter may be damaged. Check the circuit with a multimeter in continuity mode.

3. Relay fault. In some trim levels Tiida C11 The cigarette lighter is connected via a relay PWR RELAY. It's also worth checking out.

4. Failure of the cigarette lighter itself. If the socket is loose or shows signs of melting inside, the entire assembly will most likely need to be replaced.

For diagnostics you will need a multimeter. Verification algorithm:

1. Turn on the ignition.
2. Connect one multimeter probe to the central contact of the cigarette lighter, and the second to the car body (ground).
3. The voltage should be 12–14 V. If not, the problem is in the wiring or fuse box.
4. Check the side contacts of the cigarette lighter - they should ring to ground.

If there is no voltage, but the fuse is intact, the problem is most likely a broken wire or a faulty relay. In this case, we recommend contacting an auto electrician.

How to extend the life of a cigarette lighter fuse

Frequently blown cigarette lighter fuse in Nissan Tiida C11 usually associated with:

• 🔌 Using powerful devices (compressors, inverters) without adapters.
• 🔋 Connecting several consumers through a splitter.
• 💧 Moisture or foreign objects entering the nest.

To avoid problems, follow these recommendations:

• 🔌 Use only certified devices with a rated current of no more than 10A (for 15A fuse).
• 🔋 Do not connect several powerful devices to the cigarette lighter at the same time (for example, DVR + navigator + phone charger).
• 🧹 Regularly clean the cigarette lighter socket of dust and debris using compressed air.
• 🔧 Check the reliability of the contacts - a loose socket can cause a short circuit.

FAQ: Frequently asked questions about the cigarette lighter fuse in Nissan Tiida C11

Is it possible to replace the cigarette lighter fuse with a more powerful one (for example, 20A instead of 15A)?

No, this is extremely dangerous! The fuse is rated for the maximum current that the wiring can handle. Installing a fuse with a larger rating will lead to the risk of wire melting and even a fire. If 15A is not enough, it is better to lay a separate line with a fuse of the required rating.

Where is the cigarette lighter relay located in Tiida C11?

In most versions Nissan Tiida C11 The cigarette lighter is connected directly through a fuse, without a relay. However, in some configurations the relay PWR RELAY may be located in the same cabin block as the fuses (usually number 5 or 6). Check the exact location according to the diagram on the block cover.

Why does the cigarette lighter fuse blow immediately after replacement?

This means that the circuit has short circuit. Most likely reasons:

• The wire from the fuse box to the cigarette lighter is damaged.
• A metal object (coin, paperclip) got into the cigarette lighter socket.
• The cigarette lighter socket itself is faulty (short circuit between the contacts).

To diagnose, disconnect the cigarette lighter from the wiring and check the circuit with a multimeter.

Is it possible to use a cigarette lighter to connect a 220V inverter?

Technically possible, but with reservations:

• The maximum power of the inverter should not exceed 150–180 W (for 15A fuse).
• It is better to connect the inverter directly to the battery through a separate fuse.
• Monitor the voltage of the on-board network - inverters greatly drain the battery.

Which fuse controls the 12V socket in the trunk (if there is one)?

B Nissan Tiida C11 The socket in the trunk (if provided) is usually connected to the fuse PWR OUTLET face value 15A (sometimes 20A). It can be located in the cabin unit number 16 or in an additional unit in the trunk. The exact location depends on the year of manufacture and market of the vehicle.