<em>Nissan Juke</em> rear wiper: how to choose, replace and repair

Rear wiper on Nissan Juke - a small but critical element, especially in rainy weather or winter. Many owners encounter problems: the brush does not clean the glass well, creaks, freezes, or stops working altogether. In this article we will look at how to choose the right rear wiper for Juke (including restyled models 2014–2023), replace it yourself and eliminate typical faults - from brush wear to motor failure.

Feature Nissan Juke — compact rear window with a non-standard shape, which requires precise selection of the wiper. Original spare parts from Nissan (article 28560-JM00A or 28560-JM00B for restyling) are expensive, but there are worthy analogues from Bosch, HELLA or DENSO. We tested popular models and compiled a rating based on price/quality ratio - the data is presented in the table below.

Rear wiper design Nissan Juke: device and principles of operation

Rear wiper on Juke consists of three key components:

• 🔧 Electric motor — located under the plastic panel in the trunk, responsible for rotating the lever. The motor runs from the on-board network 12V and is controlled via a relay.
• 🧹 Wiper blade — attached to the lever via a plastic or metal adapter. Standard length for Juke — 300–330 mm (depending on the year of manufacture).
• ⚙️ Transmission mechanism - includes a lever, rods and gears that convert the rotation of the motor into a rocking motion of the brush.

On models before 2014, a simple motor without a position sensor was used, and after restyling it appeared parking sensor, which stops the wiper in the down position. This made DIY repairs more difficult, but improved reliability. If the wiper stops in an arbitrary place, the problem is in the sensor or its wiring.

It is important to consider that Juke with the system Around View Monitor (360° camera) rear wiper may block your view. In this case it is recommended to use frameless brushes with a minimal profile, for example, Bosch Aerotwin or HELLA Hybrid.

Signs of a malfunction: when is it time to replace or repair a wiper

There are several obvious symptoms that indicate problems with your rear wiper:

• 💧 Poor glass cleaning - streaks, streaks or drops of water remain. Most often, worn brush rubber is to blame.
• 🔊 Creaking or knocking during operation - indicates wear of the plastic bushings of the lever or dirt getting into the mechanism.
• ❄️ Brush freezing in winter - if the wiper does not move after turning it on, check for ice crust on the glass or a jammed motor.
• ⚡ The wiper doesn't work at all - there may be problems with the fuse (F37 at 10A in the block under the steering wheel), relay or broken wiring.

The last point is especially dangerous. If the wiper stops responding to being turned on, first check:

1. fuse F37 (responsible for the rear wiper and washer).
2. Relay K30 in the same block - sometimes it “sticks” due to moisture.
3. Wiring under the plastic panel in the trunk - frequent fraying of the insulation.

⚠️ Attention: On Nissan Juke 2019+ rear wiper can be locked by the system Intelligent Auto Headlights (IAH). If the wiper does not work when you turn on the headlights, check the settings in the menu Settings → Lighting → Automatic mode.

How to choose a rear wiper for Nissan Juke: original vs analogues

Original brushes from Nissan guarantee a perfect fit, but their price (from 2 500 ₽) is often unjustified. We tested 5 popular analogues and compiled a comparison table:

Model	Manufacturer	Length (mm)	Mounting type	Price (₽)	Rating (1–5)
28560-JM00B	Nissan (original)	330	Hook	2 800	5
3397004665	Bosch Aerotwin	300	Universal adapter	1 200	4.8
8JL 955 425	HELLA Hybrid	320	Side Pin	950	4.5
DU-300	DENSO	300	Hook	800	4.2
R300	Valeo Silencio	300	Universal	750	4.0

The best choice in terms of price/quality ratio - Bosch Aerotwin. This frameless brush copes well with rain and snow, does not creak and lasts up to 1.5–2 years. To save money you can take DENSO DU-300, but it cleans worse in heavy rain.

How to check brush compatibility?

Compare the length of the original brush (measure with a tape measure) and the type of fastening. On Juke until 2017 the mount is used Hook 9x3, on new models - Side Pin 17mm.

When purchasing, pay attention to adapter marking. For example, brushes with fastening Push Button will not fit - they are intended for Toyota or Honda. If in doubt, take a universal model with a set of adapters, for example, HELLA 8JL 955 425.

Step-by-step instructions: how to replace the rear wiper with Nissan Juke

Replacing the brush takes no more than 5 minutes, but if you need to dismantle the motor, you will have to work hard. Let's consider both options.

1. Replacing the wiper blade

Algorithm of actions:

1. Raise the wiper arm to a vertical position (perpendicular to the glass).
2. Press the fastening latch (usually a plastic latch on the side) and pull the brush down.
3. Install the new brush by aligning the adapter with the lever until it clicks.
4. Lower the lever onto the glass and check operation.

If the brush does not come off, spray WD-40 on the mount and wait 2-3 minutes. Do not use force to avoid breaking the plastic adapter!

2. Removing and replacing the wiper motor

If the wiper does not work at all, you will need to remove the motor. It's more complicated:

1. Open the trunk and remove the plastic trim on the right (wiper side). It is attached with 4 clips.
2. Disconnect the motor power connector (white or gray connector).
3. Unscrew the 3 motor mounting bolts using a wrench. 10 mm.
4. Carefully pull out the motor along with the lever through the technological hole.

New motor (Nissan 28500-JM00A) is installed in reverse order. After replacement it may be necessary parking sensor calibration — to do this, turn on the ignition and press the wiper button on 10 seconds.

Tuning and modernization: how to improve the rear wiper

Standard wiper Juke often criticized for poor cleaning. Here are some ways to improve it:

• 🔥 Heating installation - stick it on the glass under the wiper heating tape (For example, Defa WarmWindow). This will prevent the brush from freezing in winter.
• 💦 Washer upgrade - replace the standard injector with fan-shaped (article HELLA 8EL 009 107-031). It sprays liquid better.
• 🔄 Replacing with a frameless brush - models Bosch Aerotwin or Valeo Silencio Quieter and more efficient than the original.
• 🔋 Installing an additional relay - if the motor is weak, add a relay 12V 30A for stable operation.

For owners Juke with rear view camera is useful to install wiper with light. For example, a brush HELLA LED Wiper has built-in diodes that illuminate the cleaning area in the dark.

⚠️ Attention: When installing heated glass, do not cover the rain sensor (if equipped). On Juke 2020+, the sensor is located in the upper corner of the rear window - blocking it will lead to malfunctions of the automatic wiper.

Common replacement mistakes and how to avoid them

Even experienced car owners make mistakes when working with the rear wiper. Here are the most common:

• 🔧 Incorrect brush selection — buying a model that is too long or short leads to poor cleaning or damage to the glass.
• ⚡ Ignoring the fuse - if the wiper does not work, check first F37, and do not disassemble the motor.
• 🧴 Using the wrong lubricant — WD-40 corrodes rubber and Litol freezes in winter. Better to use silicone grease.
• 🔩 Tightening the motor bolts - this leads to deformation of the fastening and play of the lever.

Critical error: trying to warm up a frozen wiper with hot water. This will lead to glass cracking due to sudden temperature changes! The correct way is to use lock defroster or warm air from a hair dryer (at a distance of 20 cm).

Another typical problem is mechanism cable break. If, when you turn on the wiper, you hear the sound of the motor running, but the lever does not move, check the integrity of the cable. On Juke it goes from the motor to the lever through a plastic casing. Replacing the cable is only possible by removing the entire mechanism.

Care and prevention: how to extend the life of your rear wiper

The service life of a wiper depends on care. Here are some tips:

• 🧼 Wash your brush once a month with warm water and soap - this will remove dirt and grease that destroy rubber.
• ☀️ Park in the shade - Ultraviolet radiation makes rubber brittle. Use wiper cover (sold in auto stores).
• ❄️ Raise the wiper in winter before parking - this will prevent freezing to the glass.
• 🛢️ Fill the washer with high-quality liquid — cheap compounds contain aggressive additives that corrode rubber.

To clean glass, use special wipes for car windows no alcohol. Alcohol solutions dry out the rubber of the brush, reducing its service life to 3–6 months.

FAQ: answers to frequently asked questions

Can I install a rear wiper from another Nissan model?

Theoretically, yes, but only if the length of the brush and the type of fastening match. For example, a janitor from Nissan Note (article 28560-BM40A) fits in size, but has a different fastening (Bayonet instead of Hook). An adapter will be required.

Why does the rear wiper only work at one speed?

On Nissan Juke The rear wiper has only one operating mode (unlike the front wipers). If it starts to work slower, check the voltage on the motor (it should be 12V). There may be problems with the relay or contact oxidation.

How to remove the wiper lever if it is stuck?

Use a penetrating lubricant Liqui Moly LM-40 and gently tap the base of the lever with a hammer through the wooden spacer. Do not use force - the lever may break, and replacing it will cost 5 000+ ₽.

Is it possible to turn off the rear wiper completely?

Yes, but it's not recommended. To disconnect, remove the fuse F37 or disconnect the motor connector. However, this will also disable the rear window washer. An alternative is to install a switch button in the power wire break.

Which washer fluid is best for winter?

The best option is washer concentrate with freezing temperature -30°C (For example, Liqui Moly Antifrost or SONAX Xtreme}). Do not use diluted alcohol - it evaporates faster than water and leaves streaks.