Cigarette lighter in Nissan Tiida - one of the most popular interior elements, especially if you actively use gadgets, a DVR or chargers. But what if it suddenly stopped working? In 90% of cases, the problem lies in a blown **fuse** - a small but critical component of the electrical circuit. Finding it is not so easy: depending on the year of manufacture and configuration Tiida (C11 or C13) fuse location and rating may vary.

This article will help you determine exactly where the cigarette lighter fuse is located in your Nissan Tiida, how to check and replace it without contacting service. We will analyze fuse box diagrams, typical causes of burnout, and also give practical diagnostic tips. If you have never opened a mounting block, don’t worry: step-by-step instructions with photos and videos will make the process clear even for beginners.

Nissan Tiida models: where to look for the cigarette lighter fuse?

In line Nissan Tiida There are two generations that are relevant for the Russian market:

  • 🔹 Tiida C11 (2004–2012) - first generation known as Nissan Versa in some countries. The cigarette lighter fuse is located here in salon block (under the dashboard on the driver's side).
  • 🔹 Tiida C13 (2012–2019) - restyled version with updated electrics. In these models, the fuse can be located both in the passenger compartment and in engine compartment, depending on the configuration.

The key difference is in the load distribution scheme. For example, in Tiida C13 with multimedia system Nissan Connect The cigarette lighter is sometimes connected to the same fuse as the USB port. This means that if you burn out, you will lose the functionality of both devices.

📊 What model of Nissan Tiida do you have?
  • Tiida C11 (2004–2012)
  • Tiida C13 (2012–2019)
  • I don't know how to determine
  • Other model

To avoid guessing, check fuse number according to the table below. To do this, it is enough to know the year of manufacture of the car and the type of body (sedan or hatchback - in Tiida this does not affect the placement, but may affect the denomination).

Fuse box diagrams: where exactly to look?

B Nissan Tiida fuses are distributed over two main blocks:

  1. Salon block — located under the instrument panel on the driver's side. To gain access, you need to snap off the cover (it is secured with latches).
  2. Engine compartment block - located next to the battery (in Tiida C13 may be hidden by a plastic cover).

In most cases, the cigarette lighter fuse is in salon block, but there are exceptions. For example, in Tiida C13 with option Premium Package it can be placed in the engine compartment to evenly distribute the load.

Model Year of manufacture Fuse number Denomination (A) Location
Tiida C11 2004–2012 F30 15 Salon block
Tiida C13 2012–2016 F27 20 Salon block
Tiida C13 2017–2019 F15 20 Engine compartment block
Tiida C13 (with Nissan Connect) 2015–2019 F28 15 Salon block

Important! In some versions Tiida C13 The cigarette lighter fuse can be combined with the fuse ACC (additional equipment). In this case, its denomination will be 25 A, not 15 or 20. Check this using the diagram on the back of the block cover.

How to check the circuit on the block cover?

On the inside of the mounting block cover there is a detailed diagram identifying each fuse and relay. If the diagram has been erased, you can find it in electronic form upon request "Nissan Tiida [year] fuse box diagram"or download from the official Nissan website in the "Technical Documentation" section.

Step-by-step instructions: how to find and replace the fuse

If you are convinced that the problem is in the fuse, follow these instructions. You will need:

  • 🔧 Flat screwdriver (for removing the block cover).
  • 🔍 Flashlight (to better see the markings).
  • 🔌 A new fuse of the required denomination (buy in advance, as the store may not have rare denominations).
  • 📱 Multimeter or tester (optional, for checking the circuit).

Step 1: Turn off the power.

Turn the ignition key to position OFF and remove it. This will prevent short circuits when replacing. If in your Tiida button installed Start/Stop, press it without pressing the brake pedal to put the system into ACC OFF.

Step 2: Remove the fuse box cover.

For the interior unit:

  1. Lower the steering column to the lowest position for convenience.
  2. Find the plastic cover under the dashboard to the left of the steering wheel (it has latches on the sides).
  3. Use a flathead screwdriver to pry it open and pull it towards you.

For the engine compartment:

  1. Open the hood and locate the black plastic box next to the battery.
  2. Unhook the two latches on the sides and lift the cover up.

☑️ Preparing to replace the fuse

Done: 0 / 5

Step 3: Find the correct fuse.

Use the diagram on the back of the lid or the table in this article. Fuses are usually marked with letters and numbers (for example, F27). If the marking is erased, refer to the color:

  • 🔴 Red - 10 A.
  • 🔵 Blue - 15 A.
  • 🟡 Yellow - 20 A.
  • 🟠 Orange - 25 A.

Step 4: Remove and check the fuse.

Take special tweezers (usually attached to the block cover) and carefully pull out the fuse. Hold it up to the light:

  • 🔥If the jumper inside is burnt out (a gap is visible), the fuse needs to be replaced.
  • ✅ If the jumper is intact, the problem may lie elsewhere (for example, in the wiring or the cigarette lighter itself).
💡

If you don't have a multimeter at hand, you can check the fuse by eye - but this method is not always accurate. For reliability, use the tester in continuity mode: touch the probes to the fuse contacts. If there is no sound signal, the fuse has blown.

Step 5: Install a new fuse.

Insert a fuse of the same rating into the socket. Never use a fuse with a higher rating - this may cause a fire in the wiring! For example, if the diagram states 15 A, don't put 20 A, even if “it’s more convenient this way.”

Step 6. Check the operation of the cigarette lighter.

Turn on the ignition and check if the cigarette lighter works. If not, the problem may be:

  • 🔌 Wiring (frayed or oxidized wires).
  • 🔋 The cigarette lighter itself (the contacts could have burned out).
  • 📱 Additional equipment (for example, in a USB hub if it is connected to the same circuit).
💡

If the new fuse blows immediately after installation, there is a short circuit in the circuit. In this case, self-repair is dangerous - contact an auto electrician!

Typical causes of a blown cigarette lighter fuse

A fuse does not simply burn out - it is always the result of a malfunction. Let's look at the most common reasons for Nissan Tiida:

  1. Using powerful devices.

    Cigarette lighter in Tiida designed for loads up to 120–150 W. If you connect:

    • 🔌 Tire compressor (power 200+ W).
    • 📱 Tablet or laptop via car inverter.
    • 🎥 DVR with a large screen and heating function.

    - the fuse will burn out almost immediately. Solution: Use a power strip with overload protection or connect high-power devices directly to the battery.

  2. Short circuit in the circuit.

    Most often occurs due to:

    • 🔌 Damaged wire insulation (for example, after unsuccessful tuning or repair).
    • 💦 Moisture getting into the cigarette lighter connector (especially important for Tiida C11 with age wiring).
    • 🔥 Burning contacts inside the cigarette lighter socket.

To diagnose, disconnect all devices from the cigarette lighter and check the circuit with a multimeter.

  • Poor quality accessories.

    Cheap chargers, power strips or adapters often cause power surges. For example, if a power strip does not have a built-in fuse, it may "overload" the circuit Tiida.

  • How to check a circuit with a multimeter?

    Switch the multimeter to continuity mode (or resistance measurement). Disconnect the fuse and touch the probes to its contacts in the socket. If the resistance approaches zero, there is a short circuit in the circuit. If it shows "OL" (open), the problem may be in the cigarette lighter itself or the wiring.

    Attention! If the fuse blows again after replacement, do not try to install a “bug” (wire or foil) in its place. This may lead to:

    • 🔥 Fire due to overheating of the wiring.
    • 💥 Fuse box failure (replacement cost - from 5,000 ₽).
    • 🚗 Problems with electronics (for example, malfunctions Nissan Connect).

    What to do if replacing the fuse did not help?

    If the cigarette lighter still does not work after replacing the fuse, the problem may be deeper. Let's consider possible scenarios and solutions:

    1. The cigarette lighter itself is faulty.

    Over time, the contacts inside the socket oxidize or burn. To check this:

    • Disconnect the negative terminal of the battery.
    • Remove the lining of the central tunnel (it is secured with latches).
    • Disconnect the cigarette lighter connector and inspect the contacts for carbon deposits.

    If the contacts are blackened, clean them with sandpaper or replace the cigarette lighter (the cost of a new one is from 800 ₽).

    2. Wiring problems.

    B Nissan Tiida The cigarette lighter wiring goes through the fuse box to the battery. Frequent problems:

    • 🔌 Broken wire (especially if it goes under the driver's floor mat).
    • 🔋 Oxidation of contacts in connectors (for example, under the dashboard).
    • 🔥 Frayed insulation (may shorten to ground).

    For diagnostics, use a multimeter in dial mode. Check the continuity of the wire from the cigarette lighter to the fuse box.

    3. Fuse box malfunction.

    If the fuse is intact, but no voltage is supplied to the cigarette lighter, the problem may be in the unit itself. Signs:

    • 🔌 Other devices connected to this unit also do not work.
    • 🔥 Traces of melting are visible on the contacts of the block.
    • 🚗 When you turn on the ignition, you can hear the smell of burning.

    In this case, the block must be replaced. For Tiida C11/C13 it costs from 3,000 to 6,000 ₽, depending on the manufacturer.

    💡

    If you are not confident in your abilities, before disassembling the interior, take a photograph of the location of all connectors and wires. This will help put everything back together without errors.

    How to extend the life of the cigarette lighter fuse?

    To avoid repeated fuse problems, follow these guidelines:

    1. Use quality accessories.

    Buy chargers and power strips from trusted brands (for example, Xiaomi, Baseus, Mystery). Avoid no-name Chinese devices - they often do not have overload protection.

    2. Monitor the total power.

    If you connect several devices at the same time (for example, DVR + navigator + phone charger), their total power should not exceed 120 W. Otherwise, use a power strip with a built-in fuse.

    3. Clean the cigarette lighter socket regularly.

    Dust and debris can cause poor contact and overheating. Clean the nest with compressed air or a cotton swab dipped in alcohol. Do not use metal objects - they may damage the contacts.

    4. Check the voltage in the on-board network.

    Voltage surges (due to a faulty alternator, for example) can cause fuses to blow. Normal network voltage Nissan Tiida13.8–14.4 V with the engine running. If it is higher or lower, contact an electrician.

    5. Install an additional fuse.

    If you often use powerful devices, you can install an additional fuse in the cigarette lighter circuit. To do this:

    • Buy a safety block with a holder (for example, Bluesea Fuse Holder).
    • Connect it in parallel with the main fuse, but with a lower rating (for example, 10 A).
    • Secure the block in a convenient place (for example, under a dashboard).

    FAQ: Frequently asked questions about the cigarette lighter fuse in Nissan Tiida

    Is it possible to use a higher rated fuse if the standard one keeps blowing?

    No! Installing a fuse with a higher rating (for example, 25 A instead of 15 A) can lead to melted wiring or even a fire. If the fuse blows frequently, look for the cause (short circuit, overload) or install an additional fuse block.

    Where to buy a fuse for Nissan Tiida?

    Fuses of standard ratings (10, 15, 20 A) are sold at any car dealership (for example, AutoDetail, Exist, Ozon). Cost - from 10 to 50 ₽ per piece. For reliability, take brand fuses Hella, Bosch or Valeo.

    Which fuse is responsible for the USB port in Nissan Tiida C13?

    In most versions Tiida C13 The USB port is connected to the same fuse as the cigarette lighter (F27 or F28, 15–20 A). However, in some configurations, USB may have a separate fuse (F10, 10 A). Check the diagram on the block cover.

    What to do if, after replacing the fuse, the clock or radio stops working?

    Most likely you accidentally touched the fuse ACC or Audio. Check fuses F18 (10 A) and F20 (10 A) - they are responsible for the audio system and clock. If the problem persists, reset the radio settings (usually you need to press and hold the button Power within 10 seconds).

    Is it possible to change the cigarette lighter in a Nissan Tiida yourself?

    Yes, replacing the cigarette lighter is a simple procedure. You will need:

    1. Disconnect battery.
    2. Remove the lining of the central tunnel (it is secured with latches).
    3. Disconnect the cigarette lighter connector and unscrew it from the socket.
    4. Install a new cigarette lighter (for example, Febi 15315 or Hella 8ZL 355 007-031).

    The cost of a new cigarette lighter is from 800 to 1,500 ₽.