The oil filter is one of those elements that directly affects the durability of the engine. Nissan Terrano. Even the highest quality motor oil will not be able to fully protect parts from wear if the filter is clogged or incorrectly selected. In this article we will figure out which filters are suitable for different generations Terrano, how to distinguish them from fakes, and why saving on this component can result in expensive repairs.

Many owners are faced with a dilemma: buy an original filter at a high price or choose an analogue from a trusted brand? We analyzed reviews from car owners, technical specifications and test results to give clear recommendations. You will also find step-by-step instructions for replacing the filter, taking into account the design nuances Terrano, which are often missed in standard manuals.

Original oil filters for Nissan Terrano: part numbers and features

Company Nissan offers original oil filters for all generations Terrano, but their part numbers vary depending on the year of manufacture and engine type. For models with gasoline engines HR16DE (1.6 l) and MR20DE (2.0 l) fits filter with catalog number 15208-9F600. The same article number is also used for diesel versions with the engine K9K (1.5 dCi), but here it is important to pay attention to the modification of the filter - some batches are supplied with a reinforced housing to work with high pressure of the fuel system.

For Nissan Terrano first generation (1986–2005) original filters are no longer produced, but they can be replaced with analogues from Mann, Bosch or Framm, corresponding to the standard JIS D1609. Important: filters for old Terrano with engines GA16DE And SR20DE have a thread M20x1.5, while modern models use threads M22x1.5. It is physically impossible to confuse them, but when ordering through online stores this is a common mistake.

  • 🔧 15208-9F600 — main article for Terrano 2014–2023 (all engines)
  • 🔄 15208-65F0A — outdated article, but still found on sale (complete analogue of 9F600)
  • ⚠️ 15208-JD00A - only suitable for diesel versions with diesel particulate filter (DPF)
  • 📦 Set 15208-4M000 — filter kit + drain plug gasket (optimal for maintenance)

Original filters Nissan supplied in branded packaging with a holographic sticker and QR code for authentication. The filter body must be engraved with the article number and manufacturer's logo. If these elements are missing, this is a fake. The price of an original filter in 2026 ranges from 800 to 1,200 rubles, depending on the region.

📊 What oil filter do you use for your Terrano?
  • Original Nissan
  • Mann
  • Bosch
  • Framm
  • Other brand

Analogues of the original filter: which brands are trustworthy?

If the original filter seems too expensive, you can consider high-quality analogues from leading manufacturers. The main thing is to make sure that they are certified to the standard ISO/TS 16949 and have permission to Nissan. Among the trusted brands:

  • 🇩🇪 Mann Filter - article number W 712/94 (complete analogue of 15208-9F600). It features an increased area of ​​the filter element.
  • 🇯🇵 Japanparts - article number FO-599S. Manufactured in the same factory as the original filters for Nissan.
  • 🇺🇸 Framm - article number PH7317. Has a reinforced body, but less dirt holding capacity compared to Mann.
  • 🇪🇺 Bosch - article number 0 451 103 336. Good price/quality ratio, but there are fakes.

When choosing an analogue, pay attention to filter element size And quality of sealing gum. Cheap filters often have a rubber ring that hardens at low temperatures, which leads to oil leaks. It is also worth checking the availability check valve — it prevents oil from draining from the filter when the engine is stopped, which is critical for Terrano with start-stop system.

Brand Article Price, ₽ Features
Mann Filter W 712/94 650–800 Extended service life, suitable for harsh operating conditions
Japanparts FO-599S 500–650 Original quality at the same price
Bosch 0 451 103 336 450–600 Often counterfeited, check the packaging
Framm PH7317 400–550 Reinforced housing, but smaller filter area

Important: filters from SCT (article SM 101) and Sakura (article C-1028) although cheaper, have low quality filter paper. Their use leads to premature clogging and a drop in oil pressure, which is especially dangerous for turbocharged diesel versions Terrano.

When and how often to change the oil filter on a Nissan Terrano?

According to the maintenance regulations Nissan Terrano, the oil filter needs to be replaced every 10,000 km or once a year - whichever comes first. However, this interval is relevant only for ideal operating conditions: high-quality oil, calm driving style, absence of dusty roads. In reality, the filter can clog much faster.

Signs that the filter needs replacement before scheduled maintenance:

  • 🔥 Increased oil consumption (more than 500 ml per 1,000 km)
  • 🚨 Oil pressure light on at idle
  • 🔊 Extraneous noises from under the hood (knock of hydraulic compensators)
  • 💨 Black exhaust (indicates oil entering the combustion chamber)

For diesel versions Terrano with engine K9K It is recommended to shorten the replacement interval to 7,500 km, since diesel fuel burns less cleanly, and the filter becomes clogged with soot deposits. It is also worth considering that when using oil with a viscosity 5W-30 or 0W-20 the filter operates under greater load due to the lower lubricant density.

⚠️ Attention: If you are using extended oil change intervals (15,000 km or more), the oil filter still needs to be changed every 10,000 km. The filter element loses its properties regardless of the condition of the oil.
💡

Before replacing the filter, warm up the engine to operating temperature (90°C). Hot oil drains better and there will be less deposits in the system.

Step-by-step instructions for replacing the oil filter on a Nissan Terrano

Replacing the oil filter with Nissan Terrano does not require special skills, but there are several nuances that distinguish this procedure from other cars. For example, the filter is located in an inconvenient place - next to the exhaust manifold, so it is difficult to do without a special puller. It is also important to install the new filter correctly to avoid leaks.

Required tools and materials:

  • 🔧 Oil filter puller (cup or chain)
  • 🛢 New oil (volume depends on the engine: 4.3 l for 2.0, 3.8 l for 1.6)
  • 🔩 14 mm wrench (for drain plug)
  • 🧰 Funnel and container for used oil (minimum 5 l)
  • 🧻rags and gloves

Step by step process:

  1. Stop the engine and let the oil drain into the pan (10–15 minutes).
  2. Lift the car on a lift or drive it into a pit. The drain plug is located at the rear of the pan.
  3. Unscrew the drain plug with a 14 mm wrench and drain the oil into a container. Be careful - the oil will be hot!
  4. While the oil is draining, unscrew the oil filter using a puller. On Terrano it is located to the right of the engine (when viewed in the direction of travel).
  5. Before installing the new filter, apply a thin layer of oil to the O-ring.
  6. Screw the filter by hand until it stops, then tighten it 3/4 of a turn (do not use a puller to tighten it!).
  7. Screw in the drain plug with a new gasket (tightening torque: 35 Nm).
  8. Fill in new oil through the filler neck and check the level with a dipstick.

Start the engine and make sure that the oil pressure lamp goes out|Check for any leaks around the filter and drain plug|Check the oil level after 5 minutes of engine operation|Reset the maintenance counter in the on-board computer (if there is a function)-->

On Nissan Terrano with diesel engine K9K after replacing the filter it is necessary bleed the system, since air may get into the oil passages. To do this:

  1. Disconnect the oil pressure sensor connector (located on the cylinder block).
  2. Crank the engine with the starter 3-4 times for 5 seconds.
  3. Reconnect the connector and start the engine.
⚠️ Attention: If the oil pressure light remains on for more than 5 seconds after replacing the filter, turn off the engine immediately! This may indicate oil pump malfunction or clogging of the oil receiver mesh.

Common mistakes when replacing the oil filter and their consequences

Even experienced car owners sometimes make mistakes when replacing the oil filter, which can lead to serious problems. For example, filter reupholstery - one of the most common causes of hull damage. On Nissan Terrano this risks the fact that during the next maintenance the filter simply will not unscrew, and you will have to cut it off or pierce it with a screwdriver.

Top 5 mistakes and their consequences:

  • 🔧 Using an old O-ring → Oil leaks and pressure drop in the system.
  • 🧴 Lack of oil on the seal of the new filter → When starting the engine, the filter may rotate or burst.
  • 🔩 Tightening the filter with a puller → Deformation of the housing, difficulties during the next dismantling.
  • 🚯 Non-disposal of old oil and filter → Environmental damage (up to 200 ml of oil remains in the filter!).
  • 📉 Ignoring checking the oil level after changing → Risk of oil starvation at first start-up.

Another common problem is buying a filter not according to the article number. For example, some owners Terrano with engine MR20DE mistakenly take a filter from Nissan Qashqai (article 15208-4M00A). They are similar in appearance, but have different throughput. As a result, the engine operates under increased load, which leads to accelerated wear of the turbine (on diesel versions) or hydraulic compensators (on gasoline versions).

What to do if the filter does not unscrew?

If the puller does not help, try the following methods:

1. Pierce the filter housing with a screwdriver and unscrew it like a lever.

2. Heat the filter housing with a hair dryer (the metal will expand and the thread will loosen).

3. Use a special key with three claws (for example, KING TONY 1033).

4. As a last resort, cut off the filter with a grinder, but this risks getting chips into the pan.

How to check the authenticity of an oil filter?

The auto parts market is flooded with fake oil filters, and Nissan Terrano no exception. Counterfeits are often externally indistinguishable from the original, but have a low quality filter element and sealing rubber. According to the study ADAC, up to 30% of filters on the Russian market are counterfeit.

Features of the original filter:

  • 📦 Packaging: Holographic Logo Sticker Nissan, barcode, QR code for verification.
  • 🔍 Housing: engraving of the article and logo on the metal (not a sticker!).
  • 🟢 O-ring: green (for fakes - black or gray).
  • 🧻 Filter element: thick paper with uniform perforation (for fakes it is loose, with visible defects).

To check authenticity, you can use the official service Nissan Parts via the link: [https://parts.nissan.eu](https://parts.nissan.eu). Enter the filter article number in the search bar and compare the photo with your product. You can also scan the QR code on the packaging - it should lead to a page with details about the filter.

Critical point: fake filters often do not have a check valve or it is made of low-quality rubber. This leads to oil draining from the filter when the engine is stopped, and the next time the engine is started, the engine runs without lubrication for the first 2-3 seconds. For Terrano with a timing chain drive, this can cause the chain to stretch after 50,000 km.

FAQ: Frequently asked questions about oil filters for Nissan Terrano

Can I use an oil filter from a Nissan X-Trail on a Terrano?

Yes, but only if we are talking about models with the same engine. For example, a filter from X-Trail with engine MR20DE (article 15208-9F600) is also suitable for Terrano with the same motor. However, diesel filters X-Trail (for example, with an engine M9R) are incompatible with Terrano due to different pressures in the system.

What happens if you don't change the oil filter when changing the oil?

If you leave the old filter, it will be clogged with deposits and will not be able to fully clean the oil. This will lead to:

  • Accelerated wear of crankshaft and camshaft bearings.
  • Clogging of oil channels and oil starvation.
  • Increased oil consumption due to increased resistance in the system.

In critical cases this may cause rotation of liners and engine overhaul.

Which filter is better - original or Mann?

Both options have their advantages:

  • Original filter is guaranteed to be compatible with the engine and has optimal flow characteristics.
  • Mann W 712/94 has a large filter element area, which increases its resource by 20–30%.

If you are exploiting Terrano in difficult conditions (dust, off-road, frequent trips over short distances), it is better to choose Mann. The original is also suitable for standard driving.

Do I need to add oil to the new filter before installation?

No, this is not necessary. Modern oil pumps Nissan Terrano are able to quickly pump the system even with a dry filter. However, if you still want to add oil, fill the filter about 2/3 full - this is enough to avoid oil starvation during the first start.

Can the oil filter be washed and reused?

Absolutely not! The filter element consists of special paper, which loses its properties after washing. In addition, small particles remain in the filter, which, when reused, will immediately enter the engine. Savings of 500–800 rubles can result in repairs costing tens of thousands.