All about lamps in Nissan Qashqai J11 (2013–2021): types, replacement and typical problems

Owners Nissan Qashqai J11 (second generation, produced 2013–2021) sooner or later face the need to replace lamps - be it a burnt-out headlight, a dim brake light, or a failed headlight. But how to understand the variety of lamp types, choose a high-quality analogue and avoid installation errors? This article will help you not only choose the right lamps for each optics of your crossover, but will also tell you about the nuances of replacement that the manufacturer is silent about in the manual.

We analyzed data from factory catalogs Nissan, reviews from owners on forums and test results of popular lamps from Philips, Osram And Koito. Particular attention was paid to typical problems after replacement - from errors on the dashboard to premature failure of new lamps. You will also learn which lamps provide maximum brightness without glare for oncoming drivers and how to extend their service life by 2-3 times.

What kind of lamps are in the Nissan Qashqai J11: complete list by position

B Qashqai J11 More than 20 types of lamps are used - from halogen in headlights to LED in interior lighting. Below is a table with factory catalog numbers and the most popular analogues. Please note: depending on the configuration and year of manufacture, some items may differ (for example, in top versions since 2017, LED brake lights have been installed).

Position	Lamp type (factory)	Power, W	Catalog number	Popular analogues
Low beam (halogen)	H7	55	26150-4M025	Philips X-tremeVision, Osram Night Breaker, Koito Whitebeam III
High beam	H1	55	26155-4M000	Philips RacingVision, Osram Cool Blue Intense
Fog lights (PTF)	H11	55	26160-4M000	Philips WhiteVision, Osram Fog Breaker
Side lights (front)	W5W	5	26100-4M000	Philips LongLife EcoVision, LED Osram LEDriving W5W
Brake/Reverse	P21/5W	21/5	26110-4M000	Philips VisionPlus, LED HELLA LED Beam

⚠️ Attention: In versions with Full LED-optics (available from 2019) low/high beam lamps and PTF are not replaceable - if they fail, the entire light module must be replaced. This applies to configurations Tekna And N-Connecta with option LED Vision Pack.

It is also worth considering that in Qashqai J11 after restyling in 2017, some types of lamps in the rear lights changed. For example, in turn signals instead PY21W began to install WY21W (with yellow glass). When purchasing, please specify the year of manufacture of your car!

How to choose lamps for Qashqai J11: halogen vs LEDs vs xenon

The choice of lamp type depends on your priorities: maximum brightness, durability or compliance with factory parameters. Let's look at the pros and cons of each option.

• 🔦 Halogen lamps - standard solution from the factory. Pros: low price, easy replacement, no problems with errors on the panel. Cons: dim light (especially in the rain), short service life (300–500 hours). Best models: Philips X-tremeVision (+130% brightness) or Osram Night Breaker (+110%).
• 💡 LED lamps - a popular upgrade. Pros: brightness up to 6000K, service life up to 50,000 hours, low power consumption. Disadvantages: possible errors in the instrumentation (requires snag), high price (from 3,000 rubles per set), risk of blinding oncoming drivers if selected incorrectly. We recommend: Philips Ultinon Pro6000 or Osram LEDriving HL.
• ⚡ Xenon lamps — installed only in lensed optics! Pros: 4300–5000K brightness, long service life. Cons: expensive replacement (from 5,000 rubles per set), requires an ignition unit, possible problems with maintenance. Can be legally installed only in the version with factory xenon (optional Xenon Headlamps).

Critical point: In 2023 in Russia it is prohibited to use LED lamps in halogen headlights unless they are certified for your model. The fine for non-compliance is 500 rubles. (Article 12.5 of the Code of Administrative Offences), but in the event of an accident this may be considered a violation of the rules for operating the vehicle.

If you choose LEDs, pay attention to models with the right light beam. Cheap Chinese lamps (for example, with AliExpress) often blind oncoming drivers due to improper placement of diodes. The best option is lamps with markings ECE R112 or SAEwho have been certified.

Step-by-step instructions: how to replace lamps in a Qashqai J11 with your own hands

Replacing lamps in Nissan Qashqai J11 does not require special skills, but there are nuances that are not written about in the manual. For example, to get to the low beam lamp, you will have to remove the air filter (in the left headlight) or the battery (in the right). Let's look at the process using the example of the most popular positions.

Replacing the low beam lamp (H7)

Tools: gloves (to avoid leaving greasy marks on the glass), Torx T20 screwdriver, flashlight.

1. Open the hood and remove the air filter cover (left headlight) or unscrew the battery mount (right headlight).
2. Disconnect the power connector from the lamp by pressing the latch.
3. Turn the socket counterclockwise and remove the lamp.
4. Install a new lamp without touching the glass! (use gloves or a cloth).
5. Reassemble everything in reverse order.

⚠️ Attention: After replacing the low beam lamp in Qashqai J11 an error may appear Check Bulb on the dashboard. This is due to the fact that the control unit detects a change in resistance in the circuit. To reset the error, follow these steps:

1. Включите зажигание (не запуская двигатель).
2. Нажмите и удерживайте кнопку сброса суточного пробега 10 секунд.
3. Выключите зажигание и снова включите.

Replacing the brake light bulb (P21/5W)

To access the rear lights, you need to open the hatch in the trunk (under the trim). Algorithm:

1. Remove the plastic plug in the trunk behind the light.
2. Rotate the lamp socket 45° counterclockwise and remove it.
3. Replace the lamp, making sure the contacts line up with the connector.
4. Check the operation of the brake light and marker (double-filament lamp).

If, after replacement, the brake light flashes or is lit at full intensity, check the contacts in the connector - they often oxidize. Clean them with alcohol or a special spray (for example, Kontakt 60).

Typical mistakes after replacing lamps and how to fix them

Even after correctly replacing the lamps in Qashqai J11 problems may arise. Here are the most common of them and solutions:

• 🚨 "Check Bulb" error does not clear - the cause may be a faulty light control unit (BCM) or an open circuit. Check fuses F37 (10A) and F38 (10A) in the mounting block.
• 💥 The lamp burns out quickly — high voltage in the on-board network is to blame (normal: 13.8–14.4V). Measure the voltage on the battery with a multimeter while the engine is running. If above 14.7V, the generator is faulty.
• 🔄 LEDs are blinking - this is due to the lamp health monitoring system (CanBus). Solution: install snag with a resistance of 6 ohms or buy lamps with a built-in driver (for example, Philips Ultinon Essence).
• 🌡️ Lamp socket melts - a sign of poor contact or the use of high-power lamps (for example, 100W instead of 55W). Replace the socket and use only certified lamps.

Most common problem — error after installing LEDs in parking lights or brake lights. B Qashqai J11 The diagnostic system is designed for halogen lamps, and if another resistance is detected, it issues a warning. Solutions:

Problem	Reason	Solution
"Check Rear Lamp" error	Low Resistance LED	Install the blende or lamps with CanBus-compatible driver
The brake light is fully lit	Oxidation of contacts	Clean contacts with alcohol or replace cartridge
Rapid lamp burnout	Overvoltage	Check the generator and relay regulator

How to extend the life of lamps in Qashqai J11: 5 proven methods

Average service life of halogen lamps Qashqai J11 - 400–600 hours, but with proper use it can be increased by 2–3 times. Here's what really works:

• 🔋 Monitor the voltage of the on-board network — if the generator produces more than 14.5V, the lamps burn out 3 times faster. Solution: check the relay regulator (part 28500-4M000).
• 🧤 Do not touch the lamp glass with bare hands — oil from the skin creates local overheating, which causes the glass to darken and burst. Use gloves or wipe with alcohol.
• 💡 Use lamps marked "Long Life" - for example, Philips LongLife EcoVision last 50% longer than standard ones. They have a reinforced filament and are filled with a special gas.
• 🚿 Wash your headlights from the inside — condensation inside the headlight accelerates corrosion of the contacts. Once a year, remove the headlight, dry it and treat the O-ring with silicone grease.
• 🔄 Do not turn on the lights when starting the engine — at the moment of start-up, the voltage in the network drops to 9–10V, and then jumps up to 14.5V. This difference reduces the life of the lamps. Turn on the light 10-15 seconds after startup.

⚠️ Attention: If in your Qashqai J11 bulbs in the same headlight often burn out, the problem may be light control unit (BCM). On the forums, owners complain about a defective batch of blocks with the article number 284B0-4M000 (2015–2016 production).Symptom: Bulbs burn out in pairs or at intervals of several days. The solution is to replace the unit (cost ~15,000 rubles) or install an additional relay in the headlight power supply circuit.

How to check the light control module (BCM)?

Open the fuse box (to the left of the steering wheel). Find the relay K30 (headlight control) and swap it with a similar one (for example, K29 - fan relay). If the problem disappears, the relay is to blame. If not, the BCM is faulty.

Review of the best lamps for Qashqai J11: tests and owner reviews

We analyzed the test results of auto logs (Behind the Wheel, Autoreview) and owner reviews Qashqai J11 on the forums (Drive2, Qashqai Club). Below are the top 5 lamps in each category based on price/quality/resource ratio.

Best H7 Halogen Bulbs (Low Beam)

Model	Brightness, %	Service life, h	Price, rub.	Features
Philips X-tremeVision +130%	+130	450	1 200	Better brightness, but short lifespan
Osram Night Breaker Laser +150%	+150	350	1 500	Cool white light (4200K)
Koito Whitebeam III	+120	600	1 800	Japanese quality, long service life
Philips LongLife EcoVision	+30	1000	800	The best choice for savings

Best H7 LED Bulbs

Among LEDs, the leaders are models with CanBus-compatible driver:

• 🥇 Philips Ultinon Pro6000 — brightness 6000K, resource 12,000 hours, no errors on the panel. Price: ~6,000 rub.
• 🥈 Osram LEDriving HL — warm white light (5000K), good focusing in reflex optics. Price: ~5,500 rub.
• 🥉 HELLA LED Beam - budget option with a 3-year warranty. Price: ~3,500 rub.

⚠️ Attention: Cheap LED lamps (for example, with AliExpress for 800–1500 rubles) often have incorrect placement of diodes, due to which the light beam is “smeared” and blinds oncoming drivers. Before purchasing, check whether the model has a certificate ECE R112 or SAE.

Frequently asked questions (FAQ)

Is it possible to install xenon in Qashqai J11 halogen headlights?

No, this is prohibited by the traffic rules (clause 3.6 "List of faults"). Xenon lamps have a different light temperature and require lensed optics. In halogen headlights, xenon blinds oncoming drivers and does not pass maintenance. The exception is versions with factory xenon (optional Xenon Headlamps).

Why does it shine dimly after replacing the low beam bulb in the Qashqai J11?

There may be several reasons:

1. Poor contact in connector - clean oxidation.
2. Low voltage in the on-board network - check the generator.
3. Low quality lamp - try a model from Philips or Osram.
4. Problem with the light control unit (BCM) - diagnostics required.

Which lamps in the Qashqai J11 PTF provide the best light in fog?

For fog lights, lamps with yellow spectrum (3000-3500K) as it cuts through fog better. We recommend:

• Philips WhiteVision (4300K) - universal option.
• Osram Fog Breaker (3400K) - especially for fog.
• Koito Yellow Beam (3000K) - maximum visibility in rain.

It is not recommended to install LEDs in PTFs - they create a “wall of light” and impair visibility.

How to reset the dashboard lamp error after replacement?

Methods for resetting the error Check Bulb:

1. Disconnect the battery terminal for 10 minutes.
2. Press and hold the mileage reset button with the ignition on.
3. Use a diagnostic scanner (eg ELM327) to reset errors.
4. Install a snag with a resistance of 6 ohms (for LEDs).

If the error appears again, check the circuit for an open or short circuit.

How much do original Nissan lamps for Qashqai J11 cost?

Prices for original lamps Nissan (2023):

• Low beam (H7) — ~800 rub. per piece (art. 26150-4M025).
• High beam (H1) — ~700 rub. (art. 26155-4M000).
• PTF (H11) — ~900 rub. (art. 26160-4M000).
• Brake light (P21/5W) — ~300 rub. (art. 26110-4M000).

Original lamps are produced Koito (Japan) and are distinguished by stable quality, but are inferior in brightness to premium analogues from Philips or Osram.