Replacing the cabin filter on a Nissan Murano Z52: a detailed guide with photos and videos

Cabin filter in Nissan Murano Z52 - this is that invisible, but critically important element that directly affects the comfort and health of the driver and passengers. Over time, it becomes clogged with dust, pollen, exhaust gases and even bacteria, turning from a protective barrier into a source of unpleasant odors and allergens. If you notice that the interior has become stuffy, the air conditioner is working less efficiently, and condensation forms on the windshield faster, it’s time to think about replacing it.

In this article we will figure out how to change the cabin filter yourself Murano Z52 (restyling 2018 and pre-restyling 2015–2017 inclusive), without resorting to service. The procedure takes no more than 15 minutes, and the savings will be from 800 to 1,500 rubles - that’s what the service station charges for this simple operation. We'll describe each step in detail, point out common mistakes, and give recommendations for choosing a filter so you can do it right the first time.

When should you change the cabin air filter on a Nissan Murano Z52?

The manufacturer recommends replacing the cabin filter every 15,000 km or once a year, but in practice this interval depends on operating conditions. If you often drive on dusty roads, sit in traffic jams or live in a region with high levels of air pollution, the filter may become unusable after 8–10 thousand kilometers.

You can determine that the filter requires replacement by the following signs:

• 🌬️ Reduced ventilation efficiency — even at maximum blowing speed, the air coming out of the deflectors is weak.
• 🤧 The appearance of foreign odors in the cabin (mustiness, mold, exhaust gases).
• 💦 Rapid fogging of windows, especially in rainy weather.
• 🚗 Increased amount of dust on the dashboard and seats.

If you ignore these symptoms, the consequences can be more serious than just discomfort. A clogged filter creates additional stress on the ventilation system, which leads to accelerated wear of the stove fan and an increase in fuel consumption by 1–2% due to increased air resistance. In addition, in advanced cases, bacteria and fungi begin to multiply in the filter, which can provoke allergic reactions in passengers.

⚠️ Attention! If a persistent smell of rot or mold appears in the cabin, this means that the filter is not just clogged, but has become a source of proliferation of microorganisms. In this case, it must be replaced immediately and the air conditioning system treated with an antibacterial compound.

Which cabin filter to choose for Nissan Murano Z52?

On Nissan Murano Z52 Two types of cabin filters are installed: ordinary dust (made of synthetic fiber) and coal (with activated carbon to neutralize odors). The original filter from Nissan has the article number 27277-JK00A (coal) or 27277-JK00B (regular). However, its price in official dealers reaches 1200–1500 rubles, while analogues from trusted brands are 2–3 times cheaper.

The table below shows the best analogues compatible with Murano Z52:

Brand	Article	Type	Price (RUB)	Features
Mann Filter	CU 29003	Coal	600–800	High dust holding capacity, reliable protection against allergens
Bosch	1 987 429 655	Coal	700–900	Three-layer structure, good filtration of small particles
Filtron	K 1354	Regular	300–450	Budget option, suitable for regions with low pollution
TSN	9.7.869	Coal	500–650	Good price/quality ratio, popular in Russia

When choosing a filter, pay attention to its dimensions: the original one has dimensions 240 × 200 × 30 mm. Some cheap analogues may be thinner or narrower, which will lead to a loose fit and unfiltered air entering the cabin. Also check for the presence of a rubber seal around the edge - it prevents gaps between the filter and the housing.

Where is the cabin air filter located in the Nissan Murano Z52?

Unlike many cars, where the filter is located behind the glove compartment or under the hood, in Murano Z52 it's hidden behind glove box (glove compartment) on the passenger side. Access to it is quite convenient, but you will need to remove the glove compartment, which can cause difficulties for beginners.

To get to the filter, follow these steps:

1. Open the glove box and remove all items from it.
2. Press the side latches of the glove box (they are located on the sides inside the box) and gently pull it towards you.
3. The glove compartment will be released from the latches and will drop down, providing access to the plastic filter cover.

Under the cover you will see the old filter, which is held in grooves. It can be removed by pulling the special handle (if there is one) or gently prying it from the side. It is important not to use force to avoid damaging the plastic housing.

Step-by-step instructions for replacing the cabin filter

Now let's move on to the replacement process itself. You will need:

• 🔧 New cabin filter (suitable in size and type).
• 🧹 Vacuum cleaner or damp cloth to clean the case.
• 🔦 Flashlight (optional, for a better view).

Follow the instructions:

1. Remove the glove compartment. Press the side latches (they are located inside the box closer to the passenger compartment) and pull the glove compartment towards you. It should come out of the grooves easily. If the latches do not budge, try pressing them on both sides at the same time.

2. Remove the filter cover. Under the glove compartment you will see a plastic lid with latches. Carefully pry them off (you can pry them off with a screwdriver, but without pressing hard so as not to break them).

3. Remove the old filter. Pull it by the edge or special handle (if it has one). Be prepared for the fact that debris may fall out of it - it is better to cover the floor of the cabin with newspaper or a rag.

4. Clean the housing. Use a vacuum cleaner or a damp cloth to remove dust and dirt from the filter seat. This will prevent debris from entering the cabin after installing the new filter.

5. Install a new filter. Pay attention to the arrow on the filter housing - it should point down (in the direction of air flow). Insert the filter into the slots until it stops.

6. Close the lid and install the glove compartment. Make sure that all the filter cover latches are locked, then put the glove compartment in place by pressing it until it clicks.

After replacement, turn on the ventilation at maximum power and check for any unusual noises or odors. If the air flows freely and it becomes easier to breathe in the cabin, the filter is installed correctly.

What to do if the glove compartment cannot be removed?

If the glove compartment latches do not budge, try lightly pressing it from top to bottom while simultaneously pressing the latches. Sometimes they jam due to deformation of the plastic. If this does not help, check if there is any object inside the glove compartment (for example, a forgotten bottle or documents).

⚠️ Attention! Some owners Murano Z52 They encounter a problem when, after replacing the filter, the glove compartment does not lock back in place. Most often this happens due to improper installation of the filter cover - make sure that it fits snugly to the housing and that all latches are locked.

Typical mistakes when replacing the cabin filter

Even such a simple procedure as replacing the cabin filter can be performed incorrectly if some nuances are not taken into account. Here are the most common mistakes and their consequences:

• 🔄 Installing the filter backwards. If you ignore the arrow on the filter housing, filtration efficiency will decrease by 30-40%. In the worst case, the filter may become deformed by the air flow.
• 🧹 Ignoring case cleaning. If you do not remove dust and debris from the seat, they will enter the cabin immediately after turning on the ventilation.
• 🔧 Damage to the glove compartment latches. If you apply too much force, the plastic clips may break, causing the glove compartment to wobble or not close.
• 📏 Buying a filter of the wrong size. A filter that is too small will not fit tightly, and a large one simply will not fit into the grooves.

Another common problem is buying fake filters. There are a lot of counterfeit products on the market under well-known brands (Mann, Bosch). You can distinguish the original from the fake by the quality of the packaging, the presence of holograms and the clarity of the print on the filter housing. Counterfeit filters often have jagged edges, thin material, and no rubber seal.

How to extend the life of the cabin filter?

Although replacing the filter is inexpensive, you can extend its life if you follow a few simple recommendations:

• 🚗 Ventilate the interior regularly. After driving in rainy weather or on dusty roads, open the windows for 5-10 minutes to remove moisture and dust.
• 🌿 Use fragrances with an antibacterial effect. They slow down the growth of microbes in the filter.
• 🔄 Periodically turn on the air conditioner at maximum power. This helps dry out the system and prevent mold.
• 🚿 Wash the floor mats and clean the interior. The less dust there is in the car, the longer the filter will last.

If you often drive off-road or in dusty conditions, you can install prefilter - a mesh made of synthetic material that traps large dust particles and prolongs the life of the main filter. Such prefilters are sold in car dealerships and cost only 200–300 rubles.

It is also worth paying attention to air purification system. In some trim levels Murano Z52 An air ionizer is provided that helps fight bacteria. If your car is not equipped with one, you can install a portable air purifier with a HEPA filter (for example, Xiaomi Mi Air Purifier Auto).

Video instructions for replacing the cabin filter

For those who perceive information better visually, we have selected a useful video with step-by-step replacement of the filter with Nissan Murano Z52. The video shows all the nuances, including removing the glove compartment and correctly installing the filter:

Video: Replacing the cabin filter for Nissan Murano Z52 (2015–2023) (duration: 8:45).

Pay attention to the points:

• How the author removes the glove compartment without tools.
• How is the filter cover secured?
• How to correctly determine the direction of installation of a new filter.

If you still have questions after watching the video, return to our text guide for more details and tips.

Frequently asked questions (FAQ)

Is it possible to drive without a cabin filter?

Technically yes, but it is highly undesirable. Without a filter, dust, pollen, exhaust fumes and even small insects will enter the cabin. In addition, the absence of a filter accelerates the wear of the heater fan and can lead to breakdown of the climate control system.

How often should I change the filter if I don't drive much?

Even with low mileage, the filter should be changed once a year. Over time, it loses its properties due to the aging of the material, even if it visually appears clean.

Is it possible to clean the old filter instead of replacing it?

No, it's ineffective. The filter consists of microscopic fibers that become clogged with dust at the molecular level. Washing or blowing will not restore its properties, but will only damage the structure.

What is the difference between a carbon filter and a regular one?

The carbon filter not only traps dust, but also neutralizes unpleasant odors due to a layer of activated carbon. It is better suited for urban conditions, but is more expensive and requires more frequent replacement (every 10-12 thousand km).

Where can I buy a cabin filter for Murano Z52 cheaper?

The lowest prices are usually in online stores (Exist.ru, Autodoc, Kolesa-darom). You can also search on Avito or at local auto stores - sometimes they have specials. The main thing is to check the originality of the product.