Owners Nissan Qashqai With a 2-liter engine, they are often faced with the question: how much oil should be filled when changing? The answer depends on the engine modification, year of manufacture and operating conditions. In this article we will analyze exact oil volumes for engines MR20DD And HR16DE, as well as the nuances of choosing lubricants.

Errors when changing the oil can lead to oil starvation, accelerated engine wear or even breakdown. Therefore, it is important not only to know the volume, but also to understand how to properly drain old oil, select a filter and avoid common mistakes. We have collected all the necessary information so that you can perform the replacement yourself or monitor the operation of the service.

How much oil is in the Nissan Qashqai 2.0 engine: official data

For Nissan Qashqai second generation (J11) with a 2-liter gasoline engine MR20DD (144 hp) manufacturer specifies next oil volume for a complete change:

  • 🔧 With filter replacement: 4.6 liters
  • 🔄 Without filter replacement: 4.3 liters
  • ⚠️ Reference level: between the MIN and MAX marks on the dipstick

These figures are valid for vehicles produced from 2014 to 2021. However, the volume may vary slightly depending on the ambient temperature and the drainage method (gravity or vacuum).

For comparison, in a 1.6-liter engine HR16DE (117 hp) oil volume is 4.3 liters with a filter and 4.0 liters without it. If you are unsure about modifying your engine, check the VIN code or markings on the cylinder block.

📊 What engine does your Nissan Qashqai have?
  • MR20DD (2.0 l)
  • HR16DE (1.6 l)
  • Other petrol
  • Diesel
  • I don't know

Table: oil volume for different versions of Qashqai 2.0

Model and engine Year of manufacture Oil volume (with filter) Oil volume (without filter) Recommended viscosity
Qashqai J10 (1.6 HR16DE) 2007–2013 4.3 l 4.0 l 5W-30, 5W-40
Qashqai J11 (2.0 MR20DD) 2014–2021 4.6 l 4.3 l 0W-20, 5W-30
Qashqai J11 (2.0 MR20DD, AWD) 2014–2021 4.8 l 4.5 l 5W-30, 5W-40
Qashqai J11 (2.0 MR20DD, restyling) 2017–2021 4.6 l 4.3 l 0W-20 (priority)

Please note: for all-wheel drive versions (AWD) the oil volume can be increased by 0.2–0.3 liters due to design features. Always check the dipstick level after replacement!

⚠️ Attention: If after changing the oil the level exceeds the MAX mark on the dipstick, this may lead to foaming and damage to the seals. Drain the excess through the drain plug.

What oil to fill in Nissan Qashqai 2.0: manufacturer's recommendations

The manufacturer recommends using oils that meet the standard API SN or ILSAC GF-5. For modern engines MR20DD viscosity is priority 0W-20 - this is due to the requirements for fuel economy and friction reduction.

However, in Russian operating conditions (especially in regions with cold winters), many owners choose more universal options:

  • ❄️ 5W-30 — the optimal choice for most regions of Russia
  • 🌡️ 5W-40 - for hot climates or intensive use
  • ⚡ 0W-20 — factory recommendation, but requires frequent replacement (every 7–8 thousand km)

Among the trusted brands:

  • 🔹 Nissan Strong Save X E 0W-20 (original)
  • 🔹 Mobil 1 ESP 5W-30 (for turbocharged and naturally aspirated engines)
  • 🔹 Liqui Moly Special Tec AA 5W-30 (approved Nissan)
  • 🔹 Castrol Edge Professional A5 5W-30 (used on a conveyor)

Avoid oils with viscosity 10W-40 and higher - they can worsen cold starts and increase fuel consumption.

💡

If you operate the vehicle in conditions city traffic jams or frequent short trips, reduce the oil change interval by 20–30%. In such modes, the oil oxidizes faster and loses its properties.

Step-by-step instructions for changing the oil in Nissan Qashqai 2.0

To change the oil yourself you will need:

  • 🔧 New oil (5 l for MR20DD)
  • 🔧 Oil filter (original - 15208-9M50A or analogues: Mann W712/94, Bosch 0 451 103 336)
  • 🔧 14 mm wrench (for drain plug)
  • 🔧 Oil filter puller
  • 🔧 Funnel and container for working out (minimum 5 l)

Sequence of actions:

  1. Warm up the engine to operating temperature (50–60°C), then turn off.
  2. Raise the car on a lift or use a viewing hole.
  3. Unscrew the drain plug (14 mm wrench) and drain the oil into a container.
  4. Replace the oil filter (pre-lubricate the O-ring with new oil).
  5. Screw in the drain plug with a new sealing ring (tightening torque: 35–40 Nm).
  6. Fill in new oil through the neck, checking the level using the dipstick.

Warm up the engine to 50–60°C|

Prepare a container for processing (minimum 5 l)|

Buy a new filter and o-ring for the plug|

Check that you have a 14mm wrench and a filter puller|

Have clean rags and gloves on hand -->

After replacement, start the engine for 1–2 minutes, then check the level and absence of leaks. Add oil if necessary.

⚠️ Attention: If the indicator on the dashboard lights up after changing the oil OIL LEVEL, this may indicate faulty level sensor or insufficient oil level. Don't ignore the signal - check the dipstick!

Common mistakes when changing oil and how to avoid them

Even experienced car owners sometimes make mistakes that can reduce engine life. Here are the most common:

  • 🚫 Underfilling or overfilling of oil. The first leads to oil starvation, the second leads to increased pressure and the risk of damage to the seals.
  • 🚫 Using the wrong filter. Aftermarket filters may have poor sealing or low flow capacity.
  • 🚫 Failure to comply with the tightening torque of the plug. Weak tightening will lead to leakage, excessive tightening will damage the thread.
  • 🚫 Changing the oil on a cold engine. In this case, up to 200–300 ml of old oil remains in the crankcase.

To avoid problems:

  • ✅ Always check the oil level 5–10 minutes after stopping the engine (this time is needed for the oil to drain into the crankcase).
  • ✅ Use a torque wrench to tighten the plug (torque - 35–40 Nm).
  • ✅ Buy filters only from trusted suppliers (original or certified analogues).
What happens if you don't change the oil on time?

If the recommended replacement interval is exceeded (15,000 km for Nissan Qashqai) the oil loses its properties:

- Viscosity increases, pumpability through the system worsens.

- Deposits accumulate on the engine walls and in the channels.

- The wear of piston rings, liners and camshafts accelerates.

- Risk engine jamming increases by 3–5 times, especially when operating in hot weather or at high speeds.

How often do you change the oil in Nissan Qashqai 2.0?

Official regulations Nissan provides for oil changes every 15,000 km or once a year (whichever comes first). However, these figures are based on ideal operating conditions, which are rare in Russia.

Recommended intervals for different modes:

  • 🏙️ City cycle (traffic jams, short trips): 7,000–8,000 km
  • 🛣️ Route (flat ride): 10,000–12,000 km
  • ❄️ Extreme conditions (frost below -30°C, heat above +35°C): 5,000–6,000 km
  • 🏗️ Dusty roads, off-road: 6,000–7,000 km

If you are using oil 0W-20, reduce the interval by 20% - it loses its viscosity properties faster. For oils 5W-30 And 5W-40 You can follow the standard recommendations.

💡

Regular oil changes are not a expense, but an investment in engine life. Timely maintenance avoids costly repairs and extends life. Nissan Qashqai up to 300,000 km or more.

FAQ: answers to popular questions

Is it possible to mix oils from different brands?

Mixing oils not recommended, but is allowed in emergency cases if both oils have the same viscosity and standard (for example, 5W-30 API SN). After mixing, the oil should be changed as soon as possible, as additives from different manufacturers may react.

What to do if there is a knocking sound in the engine after changing the oil?

A knocking noise after an oil change may indicate:

  • Insufficient oil level (check dipstick).
  • Using oil of unsuitable viscosity (eg 10W-40 instead of 5W-30).
  • Air entering the oil system (start the engine for 1-2 minutes, then check the level).
  • Oil pump malfunction or clogged filter (diagnostics required).

If the knocking noise persists, contact service immediately!

Which oil filter is better: original or analogue?

Original filter (15208-9M50A) guarantees compatibility, but high-quality analogues (Mann, Bosch, Framm) are often not inferior in characteristics. The main thing is to avoid cheap fakes. Check:

  • O-ring included.
  • The quality of the paper filter element (there should be no gaps).
  • Strength of the case (should not deform when tightened).
Do I need to flush the engine when changing the oil?

Engine flushing not required with regular oil changes (every 10–15 thousand km). It is only required in the following cases:

  • Switching from one type of oil to another (for example, from mineral to synthetic).
  • Purchasing a used car with unknown service history.
  • Severe oil contamination (deposits on the dipstick are visually visible).

For washing, use special compounds (Liqui Moly Oil-Schlamm-Spulung) or flushing oil.

Is it possible to use 5W-40 oil instead of 5W-30?

Technically you can, but not advisable. Oil 5W-40 has a higher viscosity at operating temperatures, which can lead to:

  • Increased load on the oil pump.
  • Slight increase in fuel consumption.
  • Deterioration of pumpability during cold start.

If there is no other choice, use 5W-40 only temporarily and reduce the replacement interval to 7–8 thousand km.