Cigarette lighter in Nissan Almera - one of the most popular electrical elements, especially if you actively use car gadgets: recorders, navigators or chargers. When it suddenly stops working, the first thought is that the fuse has blown. But where to look for it? What denomination is needed for replacement? And why might a new fuse blow again after five minutes?
In this article we will look at all generations of Almera (from N16 to modern G15), we will show exact fuse locations, we’ll explain how to check them without a tester, and reveal the main reason for frequent burnout is the mistake that 80% of drivers make when connecting devices. You will also find step-by-step instructions with photos, a table of denominations and answers to frequently asked questions that are not covered even in official manuals.
Where is the cigarette lighter fuse in Nissan Almera: diagrams for all generations
The location of the fuse depends on the year of manufacture and modification Almera. In older models (N16, 2000–2006) it is located in the main fuse box under the hood, and in new ones (G15, since 2012) - in the cabin unit next to the steering wheel. Below are the exact diagrams for each generation.
For Nissan Almera N16 (2000–2006) cigarette lighter fuse is designated as CIGAR or PWR OUTLET and is located in fuse box under the hood (on the driver's side, below the battery). Denomination - 15A. On the block cover there is a diagram with the designation F17 or F20 (depending on the configuration).
B Almera Classic (N17) (2006–2012) and Almera G15 (since 2012) the fuse was moved to salon unit, which is located to the left of the steering column. Here it can be denoted as ACC SOCKET or CIGAR LIGHTER with par value 20A. There is a cigarette lighter pictogram on the unit cover - this is your guide.
- N16 (2000–2006)
- N17 Classic (2006–2012)
- G15 (2012–present)
- I don't know the model
- 🔧 N16 (2000–2006): block under the hood, fuse
F17/F20, 15A. - 🚗 N17 Classic (2006–2012): interior block, fuse
ACC SOCKET, 20A. - ⚡ G15 (2012–present): interior unit, fuse with cigarette lighter pictogram, 20A.
- 🔍 Additionally: in some trim levels G15 The fuse can be duplicated in the block under the glove compartment (less often).
| Generation | Block location | Fuse designation | Denomination (A) | Notes |
|---|---|---|---|---|
| N16 (2000–2006) | Under the hood (driver's side) | F17 or F20 |
15 | Can be combined with a 12V socket |
| N17 Classic (2006–2012) | Salon, to the left of the steering wheel | ACC SOCKET |
20 | Sometimes the fuse is duplicated F30 in the engine compartment |
| G15 (2012–present) | Interior, under the instrument panel | Cigarette lighter pictogram | 20 | In some versions the fuse is combined with a USB port |
How to check the cigarette lighter fuse without a tester: 3 working methods
Not everyone has a multimeter at hand, but this is not a problem. You can check the fuse visually or using improvised means. The main thing is turn off the ignition before starting work to avoid short circuit.
Method 1: Visual inspection. Remove the fuse with tweezers (it is usually attached to the block cover) and look at the light. If the metal thread inside is torn or melted, the fuse has burned out. B Almera G15 The fuses are translucent, so the defect is immediately visible.
Method 2: Replacing with a known good one. Take a fuse with the same rating from another slot (for example, from a radio or glove compartment light) and install it in the place of the “suspect”. If the cigarette lighter works, the problem is solved. Important: Do not use fuses with a different rating!
Method 3: Checking for spark (for experienced ones). Turn on the ignition, insert a metal object (for example, a paper clip) into the cigarette lighter and touch it to the body of the cigarette lighter. If the fuse is good, you will see a spark. Dangerous: Risk of short circuit!
If the fuse appears intact, but the cigarette lighter does not work, check socket contacts - they could oxidize or bend. To clean, use alcohol and a cotton swab.
- 👁️ Visually: thread break = burnt.
- 🔄 Replacement: Temporarily install a fuse from another slot.
- ⚡ "Spark": risky but quick method (only for experienced ones!).
- 🛠️ Nest diagnostics: oxidized contacts are a common cause of false alarms.
⚠️ Attention: Never use “bugs” (homemade wire jumpers) instead of a fuse! This may lead to fire in the cabin due to overheating of the wiring. B Almera The cigarette lighter wires are not designed for currents higher than 20A.
Step-by-step instructions: how to replace the cigarette lighter fuse in a Nissan Almera
Replacing a fuse is a simple operation, but there are nuances that will help you avoid mistakes. For example, in Almera G15 The fuse box cover is secured with latches and is easily broken if pulled in the wrong direction. Follow the instructions:
Turn off the ignition and disconnect the negative terminal of the battery (required!). This will prevent short circuit.
Locate the fuse box (see diagrams above). B G15 it is hidden behind a plastic panel to the left of the steering wheel - you need to carefully pry it off with a screwdriver.
Remove the unit cover. There is usually a diagram with symbols on the inside. Locate the cigarette lighter fuse (
CIGARor pictogram).Remove the burnt fuse with tweezers (it is built into the block cover). If you don't have tweezers, use pliers with insulated handles.
Install a new fuse same denomination (15A or 20A). Do not install a 25A fuse “just in case” - it is dangerous!
Check the operation of the cigarette lighter by connecting a known working device (for example, a phone charger).
If the fuse is blown again, look for short circuit in the wiring or a malfunction in the connected device.
☑️ What to do before replacing the fuse
B Almera N16 After replacing the fuse, you may need to reset the error in the on-board computer. To do this:
- Turn on the ignition (without starting the engine).
- Press and hold the trip mileage reset button (on the dashboard) for 10 seconds.
- Turn off the ignition and turn it on again. The error should disappear.
⚠️ Attention: If the fuse burns again after replacing, don't install a new one - this is a sign of a serious malfunction! Possible causes: a short circuit in the wiring, a faulty cigarette lighter or a connected device with high consumption (for example, a tire compressor). In this case, you need a diagnosis from an auto electrician.
Why the cigarette lighter fuse constantly blows: 5 main reasons
If a fuse blows over and over again, the problem is deeper than it seems. In 90% of cases, it is not the fuses themselves that are to blame, but improper operation or electrical faults. Here are the main reasons:
- 🔌 Connecting powerful devices. Cigarette lighter in Almera designed for maximum 120–150 W (current 10–12A). Connecting a compressor (200-300 W), refrigerator or inverter (500 W+) results in overload. Solution: use splitter with fuse or connect powerful devices directly to the battery.
- 🔥 Short circuit in socket. Oxidized or bent cigarette lighter contacts can short-circuit “+” and “-” to each other. Solution: disassemble the socket and clean the contacts (or replace the entire cigarette lighter).
- 🔋 Battery problems. Voltage surges (for example, when “lighting” from another car) can damage the fuse. Solution: Check the battery voltage (should be 12.6–14.4V).
- 📱 Poor quality chargers. Cheap Chinese phone chargers often cause overload. Solution: Use certified, labeled devices
5V/2A. - 🔧 Errors when installing an alarm or radio. If the fuse starts to burn after installing additional equipment, the technicians probably connected it to the cigarette lighter circuit. Solution: Check the wiring diagram.
How to check which device is causing the overload?
Disconnect all gadgets from the cigarette lighter. Insert a new fuse. Connect devices one at a time, starting with the least powerful ones. The one that causes the fuse to burn after connecting is the cause of the problem.
B Almera G15 common problem - poor contact in the cigarette lighter socket. Over time, the socket becomes loose and the plug of the device touches the body, causing a short circuit. Solution: bend the contacts inside the socket or install a new one (part number for G15: 28520-JM00A).
| Reason | Signs | Solution |
|---|---|---|
| Powerful device (compressor, refrigerator) | The fuse burns out immediately when connected | Use a splitter with a fuse or a direct wire from the battery |
| Short circuit in socket | The fuse burns even without connected devices | Disassemble/replace the cigarette lighter, clean the contacts |
| Poor quality charging | Burns out 5–10 minutes after connecting the phone | Replace the charger with a certified one |
How to Avoid Re-Burnout: Prevention Tips
To ensure that the cigarette lighter fuse is in Nissan Almera served for a long time, follow these rules:
- 🔌 Use a fused power strip, if you connect several devices at the same time. For example, a splitter
Blitz Wolf BW-SC01has a built-in 15A fuse and overload protection. - 📊 Control device power. The total power of all connected gadgets should not exceed 120 W (for a 20A fuse).
- 🔧 Clean the cigarette lighter socket regularly. Dust and dirt can cause oxidation of the contacts. For cleaning use alcohol and compressed air.
- 🔋 Check the on-board voltage. If it is higher than 14.5V, this may indicate a malfunction of the generator, which leads to blown fuses.
- 🚗 Avoid cheap accessories. Chargers, power strips, and inverters from unknown brands often cause problems.
If you frequently use high-power devices (such as a car vacuum cleaner), connect them directly to the battery through a 30A fuse. This will preserve the cigarette lighter circuit and prevent fuses from blowing.
B Almera N16 And N17 there is one more trick: if the cigarette lighter fuse often burns out, you can install additional fuse box with relay. This will relieve the standard circuit and connect powerful devices without risk. Connection diagram:
[Аккумулятор] → [Предохранитель 30А] → [Реле] → [Прикуриватель]
For Almera G15 useful to install USB splitter with voltmeter (For example, Xiaomi Car Charger Pro). It shows the on-board voltage and automatically turns off the power when overloaded.
Common mistakes when replacing a fuse and how to avoid them
Even experienced drivers sometimes make mistakes that lead to new problems. Here are the most common:
- 🔧 Using the wrong fuse rating. For example, instead of 20A they put 25A or 30A, thinking that “it’s more reliable.” This leads to melting of wire insulation and risk of fire.
- 🔌 Connecting devices immediately after replacement. If the cause is not corrected (for example, a short circuit), the new fuse will burn out instantly.
- 🛠️ Ignoring oxidized contacts. If you replace the fuse without cleaning the cigarette lighter socket, you risk a repeat short circuit.
- 📋 Poor polarity. In some Almera (especially N16) the cigarette lighter has a non-standard pinout. If you mix up "+" and "-", the fuse will burn out.
- 🔋 Replacing the fuse with the ignition on. This may cause a power surge and damage the on-board electronics.
Before replacing a fuse, take a photo of its location in the block with your phone. This will help avoid mixing up the fuses of different circuits (for example, the cigarette lighter and the radio).
B Almera G15 there is another pitfall: the cigarette lighter fuse may be combined with USB port. If you only replace the fuse but do not check the USB connector, the problem will remain. Check both sockets!
⚠️ Attention: If, after replacing the fuse, other devices (for example, a radio or instrument lights) stop working, then you installed the fuse in the wrong slot. Immediately replace the original fuse!
FAQ: Answers to frequently asked questions about the cigarette lighter fuse in Nissan Almera
Is it possible to install a fuse of a higher rating (for example, 25A instead of 20A)?
No! The fuse is rated for the maximum current that the wires can withstand. If you set it to 25A, the wires will overheat, their insulation will melt, and there will be a risk of fire. B Almera Cigarette lighter wires with a cross section of 0.75–1 mm² are not intended for currents higher than 20A.
The fuse is intact, but the cigarette lighter does not work. What's the matter?
Possible reasons:
- Oxidized contacts in the cigarette lighter socket (need to be cleaned).
- Broken wire from the fuse to the cigarette lighter (call with a tester).
- The cigarette lighter itself is faulty (check if it heats up when turned on).
- Ground problems (check the connection of the negative wire to the body).
What fuse is needed for Almera G15 2020?
For Nissan Almera G15 (including restyled versions) a fuse is required 20A with designation ACC SOCKET or a cigarette lighter icon. Fuse type - mini blade (small flat). Article number of the original Nissan fuse: 28650-JA00A (pack of 10 pcs.).
Is it possible to connect a second cigarette lighter in the trunk?
Yes, but you need to follow the rules:
- Use a wire with a cross-section of at least 1.5 mm².
- Install a separate fuse 15–20A below the battery.
- Connect to a circuit that turns on when you turn the ignition key (to avoid draining the battery).
- For Almera G15 fits cigarette lighter socket
28520-JM00A.
Connection diagram:
[Аккумулятор] → [Предохранитель 20А] → [Реле] → [Прикуриватель в багажник]
Why does the fuse only blow when the engine is running?
This is a sign problems with the generator. When the engine is running, the voltage in the on-board network should be 13.8–14.4V. If it is higher (for example, 15V+), this indicates a malfunction of the generator voltage regulator. Check the voltage at the battery terminals with a multimeter while the engine is running.