Selecting wiper blades for Nissan Almera G15 (2012–2022 release) is a task that at first glance seems simple, but is fraught with many nuances. Incorrectly fitted wipers not only impair visibility in the rain, but can also damage the windshield or drive mechanism. In this article we will look at official brush sizes for all modifications Almera G15, we’ll tell you about the types of fasteners, materials and give practical advice on replacement.
A special feature of this model is the change in the size of the wipers depending on the year of manufacture and configuration. For example, restyled versions (after 2015) were sometimes equipped with different windshield wipers than the pre-restyle ones. We analyzed manufacturer data, owner reviews and technical documentation to provide exact dimensions for each option.
Official wiper blade sizes for Nissan Almera G15
Standard wiper sizes for Nissan Almera G15 vary depending on the market and year of production. In most cases, cars for the Russian market are equipped with the following brushes:
- 🚗 Driver's side (left brush): 600 mm (24 in)
- 🚗 Passenger side (right brush): 400 mm (16 inches)
However, there are exceptions. For example, in some European versions Almera G15 (especially after 2017) wipers with a length of 650 mm and 450 mm were installed, respectively. To avoid mistakes, check the dimensions existing brushes using a tape measure or pay attention to the markings on the plastic case.
| Year of manufacture | Left brush (driver) | Right brush (passenger) | Notes |
|---|---|---|---|
| 2012–2015 | 600 mm | 400 mm | Pre-styling versions, standard equipment |
| 2016–2019 | 600 mm or 650 mm | 400 mm or 450 mm | Depends on market (Europe/Asia). On Russian cars it is usually 600/400 mm |
| 2020–2022 | 650 mm | 450 mm | Restyling, variations are possible for different trim levels |
If your car is equipped rear wiper (in hatchbacks or station wagons), its standard size is 300 mm. Check this in the instruction manual or on the sticker under the hood, where spare part codes are sometimes indicated.
- Frame
- Frameless
- Hybrid
- I don't know what it is
Types of fastenings: how not to make a mistake when buying
Even knowing the exact dimensions, you can buy wipers that will not fit due to incompatible fastening. On Nissan Almera G15 There are two main types used:
- 🔧 Hook (hook, U-shaped): the most common option. Suitable for most frameless and frame brushes.
- 🔧 Pin: Less common, but may occur on some modifications. Requires an adapter or special brushes.
To determine the type of mount on your vehicle:
- Raise the wiper perpendicular to the windshield.
- Inspect the connection between the brush and the lever. If you see a metal hook, this is
Hook. - If the connection is a threaded pin or snap, it is
Pin.
⚠️ Attention: When purchasing universal brushes (for example, Bosch Aerotwin or Denso) the kit often includes adapters for different types of mounts. Don't throw them away - you might need them!
If in doubt, take the old brush with you to the store or take a photo of the mount. Consultants will be able to select a compatible model. You can also use online catalogs, where the exact option will be selected based on the VIN code or car model.
Brush materials: what is better for Almera G15?
Not only its service life, but also the quality of glass cleaning depends on the material of the brush. For Nissan Almera G15 Three main types are suitable:
- 🧹 Rubber: classic option. Cheap, but wears out quickly (especially in cold weather). Suitable for budget replacement.
- 🧹 Silicone: more expensive, but lasts 2-3 times longer. Does not tan in the cold, repels water better. The optimal choice for Russian winters.
- 🧹 Graphite coating: premium option (for example, Bosch Icon). Almost silent, do not leave streaks, but the price is above average.
For regions with frequent precipitation and temperature changes (for example, Central Russia, Siberia) we recommend silicone brushes. They remain elastic at −30°C and do not crack from the sun. If your budget is limited, choose rubber brushes with Teflon coated - they retain their properties longer.
Famous brands that are suitable for Almera G15:
- 🏆 Bosch Aerotwin (frameless, silicone+graphite)
- 🏆 Denso Hybrid (hybrid, universal mount)
- 🏆 Valeo Silencio (silent, for frost)
- 🏆 Champion EasyVision (budget, but high quality)
⚠️ Attention: Cheap, unbranded brushes often have uneven pressure on the glass, which leads to “streaking” when working. This is especially noticeable at high speeds (from 80 km/h).
Step-by-step instructions for replacing brushes
Replacing wipers with Nissan Almera G15 takes no more than 10 minutes and requires no tools. Follow this algorithm:
☑️ What you will need to replace
- Preparation: Park the car on a level surface and turn off the ignition. Raise the wiper arms to the vertical position (they will lock into place).
- Removing old brushes:
- For fastening
Hook: Press the plastic lock on the side of the brush and pull it down. - For fastening
Pin: Unscrew the nut or press the latch (depending on the model).
- For fastening
After replacement, we recommend treating the arm joints WD-40 or silicone grease - this will prevent squeaking and corrosion.
If new brushes leave streaks in the first days, wipe them with alcohol - this will remove factory grease that may interfere with cleaning.
Common mistakes when choosing and replacing
Even experienced drivers sometimes make mistakes that lead to premature wear of the blades or damage to the glass. Here are the most common:
- ❌ Size mismatch: buying brushes “by eye” without measuring. For example, installing 650 mm instead of 600 mm results in hitting the plastic casing.
- ❌ Ignoring mounting type: trying to install a brush with a mount
Pinon the lever underHookwithout adapter. - ❌ Savings on quality: buying cheap rubber brushes that harden in 2-3 months.
- ❌ Incorrect installation: The fastening is not tight enough, which is why the brush “walks” and scratches the glass.
Another typical problem is mixed up sides. The driver's (left) brush is usually longer than the passenger's (right) brush. If they are swapped, visibility will deteriorate, and the levers may cling to the body pillars.
⚠️ Attention: If after replacement the wipers begin to “bounce” during operation, check the bend of the lever. Sometimes it becomes deformed from snow or ice. In this case, the lever must be replaced or straightened.
How to extend the life of your windshield wiper blades
The average service life of brushes is 6–12 months, but with proper care they can be used for up to 2 years. Here are some proven methods:
- 💧 Regular cleaning: Once a month, wash your brushes with warm water and soap to remove dirt and tar.
- ❄️ Ice protection: Before frost, treat the rubber with silicone lubricant or a special spray (for example, Liqui Moly Scheiben-Frostschutz).
- 🚿 Correct Use: Do not turn on the wipers when the glass is dry - this wears out the rubber. Use washer first.
- ☀️ UV protection: When parking for a long time in the sun, raise the wipers to prevent the rubber from melting.
If the brushes begin to creak, do not rush to change them. Often it is enough to clean the windshield of wax or silicone coatings (for example, after washing). To do this, wipe the glass white spirit or a special cleaner.
What to do if the brushes are frozen to the glass?
Never tear them off by force - this will damage the mechanism. Pour warm (not hot!) water over the sealing area or use a lock defroster. After thawing, treat the rubber with silicone lubricant.
Where to buy brushes for Nissan Almera G15: overview of options
Wiper blades for Almera G15 can be purchased in several places. Let's look at the pros and cons of each:
| Place of purchase | Pros | Cons | Average price (per set) |
|---|---|---|---|
| Official dealer Nissan | Guaranteed original quality, accurate selection by VIN | Expensive (from 1500 ₽), limited assortment | 1500–2500 ₽ |
| Car dealerships (eg. AutoSpetsCenter, ATL) | Wide selection of brands, you can touch before you buy | Prices are higher than online, the right size is not always available | 800–1800 ₽ |
| Online marketplaces (Wildberries, Ozon, Yandex Market) | Low prices, customer reviews, delivery | Risk of running into a fake, difficult to check the fastening | 500–1500 ₽ |
| Specialized online stores (for example, Exist.ru, Autodoc) | Exact selection by model, originals and analogues | Long delivery (3–7 days) | 600–2000 ₽ |
When purchasing online, pay attention to:
- 📦 Availability of certificates: Official sellers must have documents for the goods.
- ⭐ Seller rating: Avoid stores with a rating below 4.5.
- 🔄 Return conditions: The brushes must be within warranty (usually 14 days).
If you prefer original spare parts, look for brushes with the following article numbers:
28520-BM400— left brush (600 mm)28521-BM400— right brush (400 mm)
Before purchasing, please check if the brushes are suitable for your year of manufacture. For example, for Almera G15 2020 wipers may not fit the 2013 model due to modified mounting.
FAQ: Answers to frequently asked questions
Is it possible to install larger brushes than the manufacturer recommends?
No, this will lead to several problems:
- The brushes will cling to the plastic casing or body pillars.
- The load on the windshield wiper motor will increase, which will shorten its service life.
- Aerodynamics will deteriorate - at high speeds the wipers may “lift”.
The maximum deviation from the standard size is ±20 mm (for example, instead of 600 mm you can put 580 or 620 mm).
How do you know when it's time to change your brushes?
Signs of wear:
- Streaks or stains remain on the glass after work.
- The brushes “jump” or make squeaking noises.
- The rubber is cracked or peeling.
- Visibility has deteriorated in the rain (especially noticeable at night).
Also check the brushes before winter - if the rubber becomes tanned in the cold, they need to be replaced.
Will brushes from Nissan Note or Micra fit?
Partially. Some models Nissan Note (for example, E12) have the same wiper dimensions (600/400 mm), but the mounting may differ. U Micra K13 often used mount Pin, whereas Almera G15 — Hook. Before purchasing, check the types of fasteners.
What to do if new brushes leave streaks?
Causes and solutions:
- Factory lubricant: Wipe the brushes with alcohol or soapy water.
- Dirty glass: Clean it of wax or silicone with a special cleaner.
- Incorrect installation: check whether the brushes fit tightly to the lever.
- Marriage: If stains remain after all manipulations, return the brushes under warranty.
Is it possible to restore old brushes?
Yes, but this is a temporary solution:
- Rinse the brushes in warm water with vinegar (1:1) - this will remove deposits.
- Sand the rubber with fine sandpaper (1000–1500 grit) to remove burrs.
- Apply silicone lubricant to restore elasticity.
These measures will extend the life of the brushes by 1–2 months, but they will not replace a full replacement.