The oil filter is a critical element of the engine lubrication system. Nissan Qashqai J11 with gasoline engine 2.0 MR20DD. Not only the purity of the oil, but also the life of the power unit depends on its quality: a bad filter leads to accelerated wear of parts, the formation of deposits and even breakdowns. Owners are often faced with the question: which part number of the original filter is suitable for their car, and what analogues can be used without risk to the engine?

In this article we will look at all current articles oil filters for Qashqai J11 2.0 petrol, we will compare original parts with popular substitutes, tell you about the nuances of choice and give step-by-step instructions for replacement. You will also learn what mistakes are most often made when installing a new filter and how to avoid them.

Original oil filters for Nissan Qashqai J11 2.0: part numbers and features

Factory catalog number of the oil filter for Nissan Qashqai J11 with engine MR20DD (2.0 petrol) — 15208-9F60A. This article is relevant for all modifications of the model released from 2014 to 2021. It is important to note that the filter 15208-9F60A also suitable for other group vehicles Renault-Nissan with similar motors, for example, X-Trail T32 or Renault Koleos.

Original filter from Nissan has the following characteristics:

  • 🔧 Mounting type: threaded (screw-on)
  • 📏 Dimensions: height 76 mm, diameter 65 mm, thread M20×1.5
  • 🛢️ Bandwidth: up to 10 l/min at operating pressure
  • 🔄 Valve: reverse (prevents oil from draining after stopping the engine)

Cost of the original filter 15208-9F60A in official dealerships ranges from 800 to 1,200 rubles. However, many owners prefer analogues, which are often not inferior in quality, but are cheaper. We'll talk about them in the next section.

⚠️ Attention: There are counterfeits of original filters on the market Nissan with article number 15208-9F60A. They can be distinguished by the quality of packaging (the original has thick cardboard with a hologram) and weight (counterfeit goods are usually 20–30% lighter).

The best analogues of oil filters: comparison of brands and articles

If the original filter seems too expensive or is not available, you can consider high-quality analogues from trusted manufacturers. The main thing is to choose parts with the same technical parameterslike 15208-9F60A. Below is a table with the best substitutes:

Brand Article Country of origin Approximate price, ₽ Features
Mann-Filter W 712/92 Germany 450–600 High quality filter element, reinforced housing
Bosch 0 451 103 336 Poland/Germany 500–700 Good dirt holding capacity, reliable check valve
Framm PH9688 USA/China 350–500 Budget option, but the quality of the filter paper is worse than Mann
Mahle OC 593/3 Germany 600–800 Optimal price/quality ratio, long service life
Sakura C-1016 Japan 400–550 A good alternative to the original, but there are fakes

When choosing an analogue, pay attention not only to the price, but also to country of origin. For example, filters Framm Chinese-made ones are often inferior in quality to those made in the USA. It is also worth checking the availability check valve — without it, after stopping the engine, the oil will flow into the sump, which will lead to oil starvation the next time it is started.

📊 What oil filter do you use on your Qashqai J11?
  • Original Nissan 15208-9F60A
  • Mann-Filter W 712/92
  • Bosch 0 451 103 336
  • Framm PH9688
  • Other brand

When and how often do you need to change the oil filter on a Qashqai J11 2.0?

According to the maintenance regulations Nissan Qashqai J11, the oil filter must be replaced every 15,000 km or once a year (whichever comes first). However, this interval is only relevant for ideal operating conditions:

  • 🛣️ Driving on clean roads without dust and dirt
  • 🌡️ Moderate climate (no extreme temperatures)
  • 🚗 Calm driving style (without frequent acceleration and braking)

In reality, most cars are operated in more severe conditions, so recommended replacement interval — every 10,000 km. This is especially important for the engine MR20DD, which is sensitive to oil quality and filtration. Signs that the filter requires replacement ahead of schedule:

  • 🔴 Increased oil consumption (more than 500 ml per 1,000 km)
  • 🔊 Extraneous noise in the engine at idle speed
  • 🛢️ The oil quickly darkens after changing (indicates poor filtration)
⚠️ Attention: If you use semi-synthetic oil or often drive in traffic jams, the oil filter may clog faster. In such cases, check its condition every 7,000–8,000 km.

Step-by-step instructions for replacing the oil filter on a Nissan Qashqai J11 2.0

Replacing the oil filter with Qashqai J11 - a procedure that can be performed independently if you have a minimum set of tools. You will need:

  • 🔧 Oil filter puller (cup or chain)
  • 🛠️ 14 mm wrench for drain plug
  • 🛢️ New oil (4.5 l for the engine MR20DD)
  • 🧰 Funnel and container for used oil (at least 5 l)
  • 🧻rags and gloves

Sequence of actions:

  1. Warm up the engine to operating temperature (50–60°C) so that the oil becomes less viscous and drains better.
  2. Raise the car on a lift or install it on an inspection hole. An alternative is a jack with stops (but this is less safe).
  3. Drain the old oil:
    • Unscrew the drain plug with a 14 mm wrench.
    • Place the container and wait until it drains completely (about 10–15 minutes).
    • Wipe the plug and reinstall it with a new sealing washer.
  4. Replace the oil filter:
    • Using a puller, unscrew the old filter (it is located to the right of the engine when looking in the direction of travel).
    • Lubricate the rubber seal of the new filter with fresh oil.
    • Screw the filter in by hand until it stops, then tighten it ¾ of a turn (do not overtighten!).
  • Fill with new oil through the neck on the valve cover. For MR20DD you will need about 4.5 liters.
  • Check oil level with a dipstick 5 minutes after filling. It should be between the marks MIN And MAX.

    • Check for a new filter and oil|Prepare tools (puller, wrench, container)|Warm the engine to 50–60°C|Make sure there are no leaks after replacement-->

    After replacing, start the engine and let it idle for 1-2 minutes. Make sure oil pressure light does not light up on the dashboard and there are no leaks under the filter or drain plug.

    💡

    If the filter cannot be unscrewed with a puller, try piercing it with a screwdriver and using it as a lever. But be careful not to damage the seat on the engine block.

    Common mistakes when replacing the oil filter and how to avoid them

    Even experienced car owners sometimes make mistakes when replacing the oil filter, which can lead to serious consequences. Let's look at the most common of them:

    1. Unlubricated O-ring:

      If you do not lubricate the rubber gasket of the new filter with oil, it may stick to to the engine block or break during the next replacement. This also leads to a loose fit and oil leaks.

    2. Filter over-tightening or under-tightening:

      If you tighten the filter too tightly, you can damage the threads on the block or deform the housing. Loose tightening will result in oil leakage. Optimal effort - by hand + ¾ turn.

    3. Using the wrong oil:

      For MR20DD recommended oil with viscosity 5W-30 or 5W-40 (For example, Nissan Strong Save X 5W-30). Using oil that is too thick or thin will impair the performance of the filter.

    4. Ignoring the check valve:

      If the filter does not have a check valve (or it is faulty), after stopping the engine, the oil will drain into the sump. The next time you start up, there will be oil starvation, which can lead to wear. turbines And camshafts.

    ⚠️ Attention: If, after replacing the filter, the oil pressure light on the dashboard comes on and does not go out for more than 5 seconds, turn off the engine immediately! This may indicate oil pump malfunction or clogged oil channels.
    What happens if you don't change the oil filter on time?

    When the filter is clogged, the bypass valve opens and unfiltered oil enters the engine. This leads to:

    - Accelerated wear of crankshaft liners and camshafts

    - Contamination of oil channels and decreased oil pressure

    - Engine overheating due to deterioration of heat dissipation

    - Possible failure of the turbine (if there is one in the engine)

    In critical cases, the engine may seize, which will require major repairs.

    How to choose an oil filter for severe operating conditions?

    If your Nissan Qashqai J11 is used in extreme conditions (frequent off-road travel, towing a trailer, driving in extreme heat or cold), the standard filter may not cope with the load. In such cases it is recommended:

    • 🔥 Choose filters with reinforced housings (For example, Mann-Filter W 712/92 or Mahle OC 593/3).
    • ❄️ Use oil with improved cleaning properties (For example, Liqui Moly Special Tec AA 5W-30).
    • 🔄 Reduce replacement interval up to 7,000–8,000 km.
    • 🛡️ Install a magnetic drain plugwhich will catch metal shavings.

    For regions with severe frosts (below –30°C) it is better to choose filters with synthetic filter element, since it tans less in the cold. Among these options are Bosch 0 451 103 336 or Nissan 15208-9F60A (original).

    If you often drive on dusty roads, pay attention to filters with increased dirt holding capacity. For example, Framm PH9688 has a large filter surface area, but it needs to be changed more often due to rapid clogging.

    💡

    For severe operating conditions, the optimal choice is filters with a metal body and synthetic filter paper. They are more expensive, but more reliably protect the engine from wear.

    FAQ: Frequently asked questions about oil filters for Nissan Qashqai J11 2.0

    Can I use an oil filter from a Nissan Qashqai J10 on the J11 model?

    No, filters from Qashqai J10 (article 15208-4M50A) are not suitable for J11 with engine MR20DD. They have different sizes and threads (M22x1.5 instead of M20x1.5). Installing an incompatible filter will result in oil leakage or seat damage.

    Which filter is better - the original or the Mann-Filter?

    Original filter Nissan 15208-9F60A And Mann-Filter W 712/92 almost identical in quality. The only difference is the price: Mann usually 30–40% cheaper. If a guarantee of compatibility is important to you, choose the original. If you want to save money without losing quality, take it Mann.

    What should I do if oil leaks after replacing the filter?

    There may be several reasons:

    1. If the filter is not tightened properly, tighten it ¼ turn.
    2. The sealing ring is damaged - replace the filter.
    3. The seat on the block is dirty - clean it of the old gasket and oil.
    4. The filter is skewed during installation - remove and reinstall.

    If the leak continues, check the drain plug and oil pan for damage.

    How much oil should I pour into the MR20DD engine after replacing the filter?

    Total engine oil volume MR20DD — 4.5 liters (including filter). After replacing, start the engine, let it run for 1-2 minutes, then check the level with a dipstick. If necessary, top up to the mark MAX.

    Is it possible to wash the oil filter before replacing it?

    No, washing the oil filter is useless and even harmful. The filter element is made of special paper, which loses its properties after washing. In addition, contaminants remain in the filter housing, which will immediately enter the new oil. It is better to always install a new filter.