Light bulbs in Nissan Note E11: how to select and replace without errors

Owners Nissan Note E11 (2006–2013 model years) sooner or later face the need to replace light bulbs - be it a burnt-out headlight, parking light or brake light. It would seem a simple procedure, but there are a lot of nuances here: from selecting the right type of base to the risk of damaging the plastic latches during dismantling. In this article we will analyze all types of lamps for Note E11, their articles, replacement features and we will give practical advice on how to avoid common mistakes.

A feature of this generation is compact block headlights with combined functions (for example, marker + turn signal in one housing), which complicates access to the lamps. In addition, depending on the configuration (Visia, Acenta, Tekna) and year of manufacture (pre-restyle/restyle 2010), the types of socles may differ. We have collected current data on original Nissan articles and analogues from Osram, Philips, Koito, and also added instructions with photos for self-replacement.

Types of lamps in Nissan Note E11: complete compatibility table

B Nissan Note E11 lamps of three main categories are used: lighting (headlights, dimensions), signaling (turn signals, stops) and internal (interior lighting, glove compartment). Below is a summary table with caps and power for all positions. Please note: the data is valid for European and Japanese versions, for Asian markets (for example, Note E11 right-hand drive) there may be differences.

Position	Base type	Power, W	Original article number	Popular analogues
Low/high beam (halogen)	H4	60/55	26150-4M000	Osram 64193, Philips 12342PRC1, Koito H401
Side lights (front)	W5W (baseless)	5	26110-4M000	Osram 2825, Philips 12960WVX2
Front turn signal	PY21W (orange)	21	26130-4M000	Narva 47661, GE 52560
Brake light/tail marker	P21/5W (double strand)	21/5	26140-4M000	Osram 7506, Philips 12586CP
Number plate illumination	W5W	5	26160-4M000	Any W5W with white light

⚠️ Attention: In versions with xenon headlights (optional for complete set Tekna) lamp is used D2S (article 26150-4M010). Replacing xenon requires mandatory calibration in the service - independent installation without adjusting the light beam is prohibited by traffic regulations.

For rear lights (stop lights, turn signals, reverse) in Note E11 a single unit is used, where the lamps are replaced from the trunk side. Access to them is blocked by the casing - it must be carefully removed so as not to break the plastic clips.

How to choose lamps: halogen vs LEDs vs xenon

When choosing lamps for Nissan Note E11 owners are faced with a dilemma: stick with the standard halogen, switch to LEDs, or take a chance with xenon. Let's consider the pros and cons of each option, as well as legal nuances.

• 🔦 Halogen lamps: Cheap, easy to replace, do not require modifications. Disadvantages: short service life (1-2 years) and dim light compared to LED. We recommend Osram Night Breaker or Philips X-tremeVision for better visibility.
• 💡 Light Emitting Diodes (LED): Energy efficient, lasts up to 5 years, bright white light. But! B Note E11 standard optics are not designed for LED - errors on the device are possible (Check Bulb) and glare for oncoming drivers. For legal installation you need lamps with CAN bus snag (For example, Morimoto XB).
• ⚡ Xenon (HID): Maximum brightness and durability, but prohibited for installation in halogen headlights (fine 500 rubles + forced removal under Article 12.5 of the Administrative Code). Allowed only in standard xenon units (Tekna).

🔹 Important point: If you decide to install LEDs in your turn signals, choose models with built-in resistor (For example, Philips LED PY21W), otherwise they will flash rapidly due to low resistance.

Step-by-step instructions: how to replace an H4 low beam bulb

Replacing the low/high beam lamp (H4) in Nissan Note E11 - the most popular procedure. It does not require special tools, but you will need to be careful not to damage the plastic housing of the headlight unit. Follow the instructions:

1. Open the hood and disconnect the negative terminal of the battery (to avoid short circuit).

2. Remove the rubber boot from the back of the headlight unit by pulling it towards you.

3. Disconnect the power supply from the lamp by pressing the latch.

4. Release the spring clip holding the lamp by pulling it up and to the side.

5. Remove the old lamp H4, holding it by the metal base (do not touch the glass bulb!).

6. Install the new lamp, aligning the tabs on the base with the grooves in the headlight. Secure with a spring clip.

7. Connect the power supply and return the boot to its place.

⚠️ Attention: After replacement, check the light adjustment! B Note E11 mechanical headlight range control (lever under the steering wheel). If the light has gone up or to the side, adjust it according instructions below.

🔧 Advice: If the lamp H4 often burns out, check the voltage in the on-board network with a multimeter. The norm is 13.8–14.4 V. Excess (for example, due to a faulty generator) reduces the service life of the halogen by 2–3 times.

Replacement of rear lamps: brake lights and dimensions

Access to rear lamps Nissan Note E11 carried out through the trunk. The main difficulty is removing the casing, which is attached to plastic clips. be careful not to break them. Here is a step-by-step algorithm:

1. Open the trunk and remove the carpet (if any) on the right or left side (depending on which light you are changing).

2. Carefully pry up the trunk trim with a flat-head screwdriver or plastic pick. Start from the bottom corner - the clips are weaker there.

3. Unscrew the two screws securing the flashlight (using a Phillips screwdriver).

4. Pull the flashlight unit towards you without disconnecting the power supply. Turn the lamp socket counterclockwise and remove it.

For replacement P21/5W (stop + clearance) simply remove the old lamp from the socket and install the new one, aligning the protrusions. Make sure the lamp is seated tightly, otherwise there will be flickering.

What should I do if the lamp does not light after replacement?

Check the fuse F37 (10A) in the mounting block - it is responsible for the brake lights. If the fuse is intact, inspect the power supply for oxidation or check the voltage at the contacts with a multimeter.

Adjusting headlights after replacing lamps

Even if you installed a lamp of the same model as the old one, after replacing necessarily check the light adjustment. B Nissan Note E11 The headlight range control is mechanical, and its settings may be lost. For self-adjustment:

1. Place the car on a flat area 5 meters from the wall (for example, a garage door).

2. Turn on low beam. The boundaries of the light beams should be clearly visible on the wall.

3. On the back of the headlamp, find two adjustment screws:

- Upper screw (hexagon) - responsible for vertical position.

- Bottom screw (for a Phillips screwdriver) - behind horizontal.

4. Adjust the beam so that its upper border is 5–7 cm below the level of the headlights (marked on the wall), and the break point (“tick”) is to the right of the center.

⚠️ Attention: If after adjustment the light still blinds oncoming drivers, check:

- Correct installation of the lamp (top/bottom may be mixed up).

- The condition of the headlight reflector - over time it becomes cloudy, which distorts the light beam.

Common mistakes and how to avoid them

Even experienced car owners make mistakes when replacing bulbs. Note E11. Here are the most common ones and how to prevent them:

• 🧤 Touching a halogen lamp bulb: Grease marks from fingers lead to local overheating and rapid burnout. Always use gloves or wipe the flask with alcohol.
• 🔧 Use of force when removing a cartridge: The plastic latches in the headlight units are fragile. If the socket does not budge, check whether there is a hidden latch (for example, in the rear lights, you must first press the latch).
• ⚡ Ignoring polarity: In lamps P21/5W And W5W It is important to connect “+” and “–” correctly. If the lamp does not light, turn it over in the socket.
• 🔍 Buying cheap analogues: Lamps from unknown brands (for example, “no-name” from AliExpress) often have unstable parameters, which leads to flickering or overheating. Optimal balance of price and quality - Osram or Philips.

📌 Useful lifehack: If the lamp H4 burns out more than once a year, install voltage relay (For example, Bosch 0332019150). It stabilizes the power supply and extends the service life of the halogen by 30–40%.

Where to buy lamps for Nissan Note E11: proven options

When purchasing lamps for Nissan Note E11 It is important to avoid fakes. Here are reliable sources:

• 🛒 Official Nissan dealers: Guarantee of original articles, but prices are inflated (for example, lamp H4 costs 800–1200 rubles).
• 🌍 Online stores:

  - Exist.ru — a wide range of analogues (Osram, Philips, Narva).

  - Autodoc.ru — convenient selection by VIN code, often there are discounts.

  - AliExpress - only for LED lamps with good reviews (for example, Auxito H4), but be prepared to wait 2-4 weeks for delivery.

• 🏬 Local stores: You can take the lamp straight away from Avtosvet or Lukoil-Avto, but check the packaging for the presence of a hologram (anti-counterfeit protection).

💰 Cost:

- Halogen H4 (Osram/Philips): 300–600 rub.

- LED H4 (Morimoto, Auxito): 2500–5000 rub.

- Brake light P21/5W: 100–200 rub.

⚠️ Attention: When purchasing LED lamps, pay attention to light temperature. For Note E11 optimally 4000–5000K (white neutral light). Lamps with 6000K and higher give a cold bluish tint, which is less resistant to fog and can raise questions from the traffic police.

FAQ: answers to frequently asked questions

Is it possible to install LED lamps in turn signals without errors?

Yes, but you need lamps with built-in resistor (For example, Philips LED PY21W). Without a resistor, the turn signals will blink 2 times faster due to the low LED resistance. An alternative is to install an external resistor (50 Ohm, 5 W) in parallel with the lamp.

Which fuse controls the low beam on the Note E11?

For low/high beam (H4) the fuse responds F25 (15A) in the mounting block (located to the left of the steering wheel under the cover). If the lamp is working, but the light does not light, check this fuse and relay K12.

What is the difference between pre-restyle (2006–2010) and restyle (2010–2013) lamps?

B Note E11 after the 2010 restyling, the shape of the headlight unit changed, but lamp bases remained the same. An exception is some versions for Japan, where turn signals use WY21W instead of PY21W. All other lamps (H4, W5W, P21/5W) are interchangeable.

Why did the light become dim after replacing the H4 lamp?

Probable reasons:

- Poor contact in the power supply (clean up oxidation).

- Low quality lamp (check the voltage with a multimeter - it should be 12-14 V).

- The headlight reflector is fogged up (you need to dry it with a hairdryer or change the seal).

Is it possible to polish cloudy headlights yourself?

Yes, for this you will need:

1. Sandpaper (800, 1000, 2000 grit).

2. Plastic polish (for example, 3M 39071).

3. Protective varnish (for example, Delta Kits).

Process: remove the headlight → matte with sandpaper → polish → apply varnish. Without varnish, the effect will last no more than a month.